Answer:
A: Experimental results will be trusted by the scientific community
only if they have been peer-reviewed.
Explanation:
It is NOT C as I have tried it, it did not work and makes no sense.
The number of particles in 8 g 02 molecules are
Answer:
cholesterol
Explanation:
gsdhudbdjbfmcjfjdncbdhdnhdndbchdncbdn f f ff
Which statement best describes the destiny of an atoms nucleus?
Answer:
The answer would be: An atom’s nucleus occupies very little of the atom’s volume but contains most of its mass
Explanation:
The atomic nucleus is the small, dense region consisting of protons and neutrons at the center of an atom.
Almost all of the mass of an atom is located in the nucleus, with a very small contribution from the electron cloud.
Refer to https://en.wikipedia.org/wiki/Atomic_nucleus for further understanding
MAZA11189 can you solve this
Answer:
The answer is below
Explanation:
A) The method of extracting essential oils from aromatic plants is important however, the process of distillation is the main method for extracting the aromatic parts of plants.
B) The condenser fan plays an important role on circulating the air across the coil to facilitate heat transfer. The condenser refrigerant and pumps it to a coil in the form of a hot gas.
What is Halo form reaction?
Answer:
Explanation:
I willl go into a bit of detail on the haloform reaction. So the first few steps involve forming an enolate using the base, typically NaOH. THe enolate and go on to do alpha halogenation 3 times. After that, is leaves a trisubstituted alpha methyl carbon with a specific halogen. This is a good leaving group in itself and can carbonyl nucleophillic substitution and turn into a carboxylic acid with a CHZ3- byproduct where Z represents a halogen.
Ne + C, which bonding is?
Answer:
bonding conductor
Explanation:
they have bond of conductor between them.
Làm thế nào để tắt mỗi chất ra khỏi hỗn hợp gồm bột nhôm bột sắt và bột gỗ?
Answer:
Dùng nam chân hút đc bột sắt ra khỏi hỗn hợp
Bột gỗ và bột nhôm thì bột gỗ tan trong nước còn bột nhôm thì không
Explanation:
Nice !Can someone help me pls
What do you think nowadays computer engineer, civil engineer or electrical engineer which one is more demanded?
19. If 23.4 grams of hydrogen gas were produced by the reaction below, how many grams of aluminum chloride were produced? (2 points) 2 Al + 6 HCl yields 2 AlCl3 + 3 H2 516 g AlCl3 774 g AlCl3 1030 g AlCl3 1550 g AlCl3
Answer:
1040
Explanation:
you can use the mole to mole ratios of aluminum chloride and hydrogen gas,you first have to find the number of moles of hydrogen gas..the number of moles of hydrogen gas are 11.7(23.4/2)
2AlCl3+3H2
2 : 3
x :11.7
3x/3=23.4/3
x=7.8g/mol
then find the number of grams of aluminum chloride
m=n×mr
=7.8×133.341
=1040g
I hope this helps and sorry if it's wrong
What does the reducing agent do in a redox reaction? (A.P.E.X)
Answer:
The reducing agent donates electron to the oxidizing agent and gets oxidized itself
Explanation:
In an oxidation-reduction reaction, also known as REDOX reaction, one of the reactants is called OXIDIZING AGENT while the other is called REDUCING AGENT. The reducing agent is called so because it reduces another substance in the reaction.
It reduces another atom/ion by donating electrons to that atom, hence, getting oxidized itself in the process. For example, in the following reaction:
H2 + F2 → 2HF
Fluorine is getting oxidized from -2 to 0 by donating electrons to H and reducing it from +2 to 0.
Answer:
Reduces another atom
Explanation:
:)
Do cycloalkanes easily take part in addition reactions?
Answer:
The reactions of the cycloalkanes are generally just the same as the alkanes, with the exception of the very small ones - particularly cyclopropane. ... In the absence of UV light, cyclopropane can undergo addition reactions in which the ring is broken
For the reaction 2HNO3 + Mg(OH)2 + Mg(NO3)2 + 2H20, how many
grams of magnesium nitrate are produced from 3.54 mol of nitric
acid, HNO3?
O a. 220
O b. 263
O c. 1050
O d. 175
Answer:
B
Explanation:
Classify each area of study as being a branch of science or not a branch of science. If you're unsure, take your best guess.
Drag each tile to the correct location.
SCIENCE
NOT SCIENCE
astronomy
astrology
biology
chemistry
geology
physics
theology
Answer: Science : Chemistry, astronomy , biology , physics , biology ,geology. Notscience : Astrology and theology
Explanation: Astrology and theology are non scientific areas of study.
What happens when you rub a plastic ruler and bring it closer to the tissue bits
Answer:
rubbing the ruler transfers electrons from the clothe to the ruler now the ruler has excess electrons and it is negatively charged... electrons will move away from the ruler leaving a positive charge on the tissue near the ruler so they attach
I hope this helps
A hot metal plate at 150°C has been placed in air at room temperature. Which event would most likely take place over the next few minutes?
- Molecules in both the metal and the surrounding air will start moving at lower speeds.
-Molecules in both the metal and the surrounding air will start moving at higher speeds.
-The air molecules that are surrounding the metal will slow down, and the molecules in the metal will speed up.
-The air molecules that are surrounding the metal will speed up, and the molecules in the metal will slow down.
Answer:
it will dilute to its natrual state. so c
Explanation:
Explain which intermolecular force is primarily responsible for the unusually high boiling point of H2OH2O. Compare the strengths of intermolecular forces of attraction present in a sample of liquid water to the strengths of intermolecular forces of attraction present in liquid samples of H2SH2S, H2SeH2Se, and H2TeH2Te. Justify your answer using the information presented in both tables, and complete the statements below.
Answer:
See explanation
Explanation:
Intermolecular forces are forces of attraction that exist between molecules of a substance in a particular state of matter.
The dominant intermolecular force of attraction in H2O is the hydrogen bond. The hydrogen bond exists between molecules of a substance when the substance is made of hydrogen atoms bonded to atoms of a highly electronegative element. Hence, strong hydrogen bonding accounts for the high boiling point of water.
The magnitude of hydrogen bonding between molecules depends on the electro negativity of the atoms to which hydrogen is bonded.
The more the electro negativity of the atoms to which hydrogen is bonded, the greater the magnitude of intermolecular hydrogen bonding.
Since the electro negativity of elements decrease down the group, the strength of intermolecular hydrogen bonding between the molecules decreases as follows;
H2O> H2S> H2Se> H2Te
If I add sugar into water then _________________
Pls help
Explanation:
When adding sugar to water it became a syrupy solution. Here sugar acts as solute, the water acts as solvent and syrupy acts as solution. When adding sugar to water, the disaccharide of sucrose is converted into monosaccharides of glucose and fructose
Answer:
syrupy solution
PLZ HELP ME WITH MY WORK
Answer:
c. H2 andO2
I think this is the answer not sure ok
What is the atomic number of the atom in the diagram above please ?
Answer:
5
Explanation:
The atomic number is the number of protons in an atom. Protons are the positively charged particles in the nucleus. The number of protons define the identity of an element. An element with 5 protons is Boron, no matter how many neutrons may be present.
The atomic number of the atom shown in the diagram is 5.
What is the atomic number?The atomic number of an element refers to the number of protons in the nucleus of its atoms. It uniquely identifies an element and determines its chemical properties.
In the diagram, there are 5 proton numbers in the nucleus of the atom. In other words, this means that the atomic number of the atom is 5.
More on atomic numbers can be found here: https://brainly.com/question/14190064
#SPJ3
How are energy and mass connected during the formation of an
atom?
Answer:
Energy is absorbed, so the mass is increased. Energy is released, so the mass is increased
one similarity between physics and chemistry is...
Answer:
They are branch of science.
Explanation:
hope this helps
Answer:
Branch's of science yk
Explanation:
I'm smart lol
balance the equation:2Na+3H2O-2NaOH+H2
Answer:
2Na + 2H2O → 2NaOH + H2
Explanation:
A balanced equation is an equation for a chemical reaction in which the number of atoms for each element in the reaction and the total charge are the same for both the reactants and the products.
As the mass of the nucleus increases, what happens to the ratio of neutrons to protons in stable isotopes? A. The neutron:proton ratio decreases. B. The neutron:proton ratio increases. C. The neutron:proton ratio remains 1:1. D. The neutron:proton ratio remains 1.5:1.
What is the molecular geometry of a molecule made of two atoms that share one pair of electrons and have no lone electrons pairs?
trigonal pyramidal
linear
trigonal planar
bent
Answer:
linear
Explanation:
Actually I consulted various sources too and that was the most sought answer,I just decided to answer you before studying it too
Drag each tile to the correct box.
Match the hydrocarbon names and structural formulas.
2-butene
2-methylbutane
2-butyne
H
1
HC-H
H H
H
1
H-CC c C-H
1 1
H
H H
H
H
C-H
H-C-CEC
1
H
H
21 Edmentum. All rights reserved.
this is my attachment answer hope it's helpful to you
to make 400 gram solution with a mass by a mass concentration of 6 % how much salt and water you need to mix
Answer:
[tex]400 \div 6 \\ \\ [/tex]
Write the relation of M3 with its multiples
Explanation:
HI friends good morning
Differentiate between emperical and
molecular formula. Give an example of
a substance having different emperical
and molecular formula
Answer:
Here’s an example:
CH (methylene) is the empirical formula.
C2H2 is a molecular formula. It is a gas called Ethyne.
C8H8 is an oily liquid called Styrene. It is also a molecular formula.
Now compare: even though the empirical formula for these compounds is the same, they have different molecular formulas and different properties.
Explanation:
Some background information:
The empirical formula is the formula with the lowest whole number ratio of an element in a compound. A molecular formula is the chemical formula of a (molecular) compound. The molecular formula gives us the exact number of atoms or moles in that compound.
I have attached pictures for a better understanding of the empirical formula.
Which of the following would increase the pressure of a gas in a container?
A. Decreasing the kinetic energy of the gas
B. Increasing the temperature of the gas
C. Decreasing the number of gas particles
D. Increasing the volume of the container
The only option that would increase the pressure of a gas in a container is B. Increasing the temperature of the gas. Option B
To understand which factor would increase the pressure of a gas in a container, we need to consider the relationship between pressure and various variables in the ideal gas law and the kinetic theory of gases.
The ideal gas law states that pressure (P) is directly proportional to the number of gas particles (n), the temperature (T), and inversely proportional to the volume (V) of the container. Mathematically, it can be expressed as:
PV = nRT
where R is the ideal gas constant.
Based on this equation, we can analyze the options given:
A. Decreasing the kinetic energy of the gas: According to the ideal gas law, temperature is directly proportional to pressure. Therefore, decreasing the kinetic energy (which is related to temperature) would decrease the pressure, not increase it.
B. Increasing the temperature of the gas: As mentioned above, temperature is directly proportional to pressure. Increasing the temperature of the gas would increase its kinetic energy, resulting in more frequent and energetic collisions with the container walls, thus increasing the pressure.
C. Decreasing the number of gas particles: According to the ideal gas law, the number of gas particles (n) is directly proportional to pressure. Therefore, decreasing the number of gas particles would decrease the pressure, not increase it.
D. Increasing the volume of the container: According to the ideal gas law, volume (V) is inversely proportional to pressure. Increasing the volume of the container would decrease the pressure, not increase it.
For more such questions on pressure visit:
https://brainly.com/question/24719118
#SPJ8
What amount of SeC16 is needed to produce 4.45 mol of chlorine gas in the
reaction Seclo +0 218) —SeO, +3Cl2te)?
2.85 mol
0.95 mol
5.70 mol
8.55 mol
1.49 mol
Answer:
1.48 moles of SeCl6 are needed
Explanation:
Based on the reaction:
SeCl6 + O2 → SeO2 + 3Cl2
1 mole of SeCl6 reacts producing 3 moles of Cl2.
To solve this question we need to use the conversion factor:
1mol SeCl6 = 3mol Cl2
As we want to produce 4.45 moles of Cl2, we need:
4.45 mol Cl2 * (1mol SeCl6 / 3mol Cl2) =
1.48 moles of SeCl6 are neededCâu 36: _VD _Hình lập phương có thể tích là 1253 thì diện tích đáy là:
A. cm2 B. 5cm2 C. 25cm2 D. 52cm2
Answer:
c
Explanation:
Cạnh của hình lập phương là
³\(125 = 5cm
Diện tích đáy của hình lập phương là
5²=25cm²
Đáp án C
