The circumstances that the system is exposed to may be altered in such a way as to cause a change in the chemical equilibrium. When we do this, we are said to be "stressing the balance."
In a chemical process that has reached equilibrium, one method is to either add or remove a product or a reactant. When more of a reactant is introduced, the equilibrium changes to alleviate the pressure, which results in the production of more products.
This is further explained below.
how and why this would change the pH of the solution.?Generally, When more product is introduced, the equilibrium moves away from products and toward reactants in an effort to lower the level of stress.
In the event that either the reactant or the product is withdrawn from the system, the equilibrium changes such that more of the corresponding substance is produced to compensate for the loss.
According to Ch/atelier's Principle, which claims that if a reaction in equilibrium is disturbed, the equilibrium will change to counterbalance that change, this indicates that if a reaction is in equilibrium, the equilibrium will alter to counteract that change.
If a solution has a large number of hydrogen ions, the pH of the solution will be low, and it will be classified as an acidic solution.
In conclusion, On the other hand, a solution is said to have a high pH and be in the basic state if it contains a low quantity of hydrogen ions in its composition.
The ratio of the concentration of hydrogen ions to the concentration of hydroxide ions is negative and inversely proportional.
Read more about equilibrium
https://brainly.com/question/28527601
#SPJ1
What can you say about the reactants of photosynthesis and the products of cellular respiration?
Answer:
Photosynthesis converts carbon dioxide and water into oxygen and glucose. Glucose is used as food by the plant and oxygen is a by-product. Cellular respiration converts oxygen and glucose into water and carbon dioxide. Water and carbon dioxide are by-products and ATP is energy that is transformed from the process.
Explanation:
Properties of nonmetals include
a.high boiling point.
b.ability to conduct heat.
c.dull appearance.
d.none of the above
Answer:
c.dull appearance
Explanation:
Nonmetals are dull,poor conductors of heat and electricity that have lower melting points than metals,the rest of the answer choice are properties of metal.
Hope this helps :)
Which highway run through comlumbus
Answer:
Highway 22 ,GA 31820
Explanation:
what is a good use of 385 protocol in English
Answer:
375
Explanation:
as soda gets warm, it goes flat. why? relate this to solubility.
Answer:
It's because the solubility of gases in water is inversely proportional to the temperature, so it means when the temperature is increased, the solubility decreases, and the gases tend to get out from the soda
in your own words how do plants on Earth affect the amount of carbon in Earth’s atmosphere?
Answer:
Plants take carbon dioxide out of the atmosphere, but they also have other effects, such as changing the amount of evaporation from the land surface. ... The plants absorb carbon dioxide for photosynthesis through the same pores (called stomata). But when carbon dioxide levels are high, the leaf pores shrink.
Explanation:
Why is it possible to collect hydrogen gas over water?
When refering to a gas, the higher the temperature, the faster the particles move:
True
False
Answer:
TrueExplanation:
In Gas,The movement of particles depends upon their temperature. When, the temperature is high the movement of the particles is faster.When, the temperature is low the movement of the particles is slower down and move close together.Hence,
The above statement is true for, the gas particles moves faster in high temperature.
There is 200 grams of water on a stove. The water is currently 25 C. How much energy in joules must be used to raise the water to 90 C?
Answer:
q
=
64 kJ this is answer. .
What is the mass of 1,300 cm of gasoline? The density of gasoline is 0.67 g/cm.
Answer:
Volume x Density = Mass of a substance
1300 x 0.67 = 871
The mass is 871 (unit)
wht will react with acid to giv bluish green salt nd water ??
Explanation:
When dilute HCl is added to a small amount of copper oxide in a beaker, a greenish-yellow gas is released and a bluish-green solution is formed. Since the metal oxides such as a Copper oxide (CuO) are basic in nature, it reacts with acids such as HCl to form the corresponding salt and water.
đơn chất nào sau đây tác dụng với dung dịch axit sunfuric loãng sinh ra khí ?
a đồng
b cacbon
c nhôm
d lưu huỳnh
Answer:
C. Al
Explanation:
2Al+ 3H2SO4(l)------> Al2(SO4)3+ 3H2
Two particles with the same charger will always____each other when brought close together
The kinetic energy within molecules of an object _____ when heat is added.
Answer:
As an object is heated up, its atoms and molecules move and collide faster. Geothermal energy is the thermal energy in the earth. Wind. ... total kinetic energy of the particles hat make up a substance. please mark brainliest
Explanation:
Answer: As an object is heated up, its atoms and molecules move and collide faster.
Explanation: Geothermal energy is the thermal energy in the earth. Wind. The total kinetic energy of the particles that make up a substance. Thus when the heat is added to the system, the temperature gets increases which in turn will increase the velocity of the molecule and these molecules will collide even faster .
Rheumatoid arthritis is a disorder in which the joints swell and cause pain. Rheumatoid arthritis causes the body’s own immune cells to attack the membrane of the joints. Which body system does rheumatoid arthritis affect?
Answer:
Immune system
Explanation:
Rheumatoid arthritis is an autoimmune disease. Normally, your immune system helps protect your body from infection and disease. In rheumatoid arthritis, your immune system attacks healthy tissue in your joints. It can also cause medical problems with your heart, lungs, nerves, eyes and skin.
How do ionic bonds form?
Quick
Answer:
Explanation: ionic bond, also called electrovalent bond, type of linkage formed from the electrostatic attraction between oppositely charged ions in a chemical compound. Such a bond forms when the valence (outermost) electrons of one atom are transferred permanently to another atom.
superscript Coefficient
Me think
How many grams of hydrogen are needed to fully react 621. 9 grams of nitrogen gas.
Answer:
9 grams of nitrogen gas
Explanation:
Whymilk is taken as mixture
Explanation:
Main compounds of milk are lactose and casein. And it is also called a colloidal mixture (i.e. in which one substance of microscopically dispersed insoluble or soluble particles is suspended throughout another substance). Therefore milk is regarded as a mixture not as a pure substance. So this is the required answer.
Are we alone in the universe?
Answer:
no ofcourse not!
Explanation:
Answer:
no
Explanation:
the universe is way too big, maybe not in a conventional form but there are definitely aliens
NEEEEEDD HELP!CHEMISTRY
1. H2O
EXPLANATIONA water molecule consists of two atoms of hydrogen linked by covalent bonds to the same atom of oxygen. Atoms of oxygen are electronegative and attract the shared electrons in their covalent bonds
ADDITIONAL INFORMATIONHow to differentiate between ionic and covalent bonds ?
There is a couple different ways to determine if a bond is ionic or covalent. By definition, an ionic bond is between a metal and a nonmetal, and a covalent bond is between 2 nonmetals. So you usually just look at the periodic table and determine whether your compound is made of a metal/nonmetal or is just 2 nonmetals.
9) What is the final pressure in the container shown below after the valve is opened and the gases are allowed
to flow? (The gases do not act)
0
4.00 am
3.00
NE
2.00 am
2.00 L
A 3.00-L container with O₂ at 4.00 atm is connected to a 2.00-L container with Ne at 2.00 atm, resulting in a final pressure of 3.20 atm in the container.
We have 2 containers connected by a valve.
One container has a volume of 3.00 L and contains O₂ at 4.00 atm. The other container has a volume of 2.00 L and contains Ne at 2.00 atm.
When the valve is opened, the total volume is the sum of the 2 containers.
[tex]V_2 = 3.00 L + 2.00 L = 5.00 L[/tex]
Assuming constant temperature and ideal behavior, we can calculate the final pressure of each gas using Boyle's law.
O₂
[tex]P_1 \times V_1 = P_2 \times V_2\\\\P_2 = \frac{P_1 \times V_1}{V_2} = \frac{4.00atm \times 3.00L}{5.00L} = 2.40atm[/tex]
Ne
[tex]P_1 \times V_1 = P_2 \times V_2\\\\P_2 = \frac{P_1 \times V_1}{V_2} = \frac{2.00atm \times 2.00L}{5.00L} = 0.800atm[/tex]
The final pressure in the container will be the sum of the final pressures of the gases.
[tex]P = 2.40 atm + 0.800 atm = 3.20 atm[/tex]
A 3.00-L container with O₂ at 4.00 atm is connected to a 2.00-L container with Ne at 2.00 atm, resulting in a final pressure of 3.20 atm in the container.
Learn more: https://brainly.com/question/1437490
In your own words, explain in a simple, short way of what the periodic table is.
Answer:
The periodic table is a chart that arranges all of the chemical elements.The chemical elements are the substances that make up all matter. The amount of tiny particles in each element is the atomic number, which is how you identify it.
Explanation:
Can somebody help me with this please?
Answer:
So what you want to do is to place sulfur on top with the two fluorine's on the bottom left and right hand side at slight angles. You don't want to make it look interconnected as one whole bond. Draw a single line from each "F" to the "S" to model two fluorine atoms bond to one sulfur atom (Single bond, only one electron is being shared between each).
What do the groups (columns) and periods (rows) tell you about the elements on the periodic table?
Answer:
Groups: The vertical column of the periodic table that signifies the number of valence electrons in an element.
Period: The horizontal rows in the periodic table that signify the number of electron shells in an element.
Explanation:
Answer:Groups: The vertical column of the periodic table that signifies the number of valence electrons in an element. Periods: The horizontal rows in the periodic table that signify the number of electron shells in an element.
Explanation:
The table has seven rows and 18 columns. Each row represents one period; the period number of an element indicates how many of its energy levels house electrons.The columns of the table represent groups, or families, of elements.
What was the flaw in reasoning that caused Mendeleev to mix up the placement of Ar and K, Co and Ni, and Te and Ni?
Answer:
Can you explain your question I don't understand
Which are effects of long-term exposure to mustard gas? Select all that apply. One, some, or all responses may be correct.
The effects of long-term exposure to mustard gas causes mortality and chronic respiratory disease.
Exposure to mustard gas in the long term can result in mortality from influenza, pneumonia as well as chronic breathing disease. Exposure for long term leads to respiratory complications and septic shock. Extensive breathing in the environment of mustard gas can cause chronic respiratory disease, respiratory infections or death.
Extensive eye exposure to this gas can cause permanent blindness. Exposure to mustard gas may also increase the chances of lung and respiratory cancer so we can conclude that mustard gas is lethal and can cause a number of diseases in a person who is exposed to it.
Learn more: https://brainly.com/question/25686553
According to the chart, very few elements are required for our planet to exist in its current state. Analysis of the chart would lead an observer to conclude that
our planet is exists in its unique state solely because of the element carbon
our planet is mainly composed of hydrogen
our planet is mainly composed of a few key elements, but other elements are present as well
our planet is composed of 92 naturally occurring elements
Answer:
the 3rd answer
Explanation:
the earth is composed of key element like carbon Oxygen nitrogen phosphorus hydrogen and sulphur CHNOPS but they are other element on earth too even though they are not as essential
Hund's rule: states that electrons always enter an empty orbital before they pair up.
Answer:
true
Explanation:
What is activation energy
Answer: Activation energy is defined as the minimum amount of extra energy required by a reacting molecule to get converted into product. It can also be described as the minimum amount of energy needed to activate or energize molecules or atoms so that they can undergo a chemical reaction or transformation.
Explanation:
When an organism dies it is exposed to many different types of biotic and abiotic factors biotic factors include?
Answer:
the organisms themselves,other organisms,interactions between living organisms, and even their waste.
