Answer:
The average atomic mass of an element is the sum of masses of it's isotopes
Each are multiplied by it's natural abundance
Explanation:
The average atomic mass of an element is the sum of masses of it's isotopes
Each are multiplied by it's natural abundance
Which force, in real life, will have the least effect on a bowling ball rolling down a lane toward bowling pins?
A) magnetism
B) air resistance
C) gravity
D) friction
Answer:
Its Friction
Explanation:
the pins are not floating and they are not a magnet and not involved with air
The force, in real life, that will have the least effect on a bowling ball rolling down a lane toward bowling pins is magnetism. The correct option is A.
What is magnetism?Magnetism is basically the force which indeed magnets exert when they attract or even repel one another. The movement of electric charges resulting in magnetism.
Every substance is composed of tiny units referred to as atoms. Each atom contains electrons, which are charged particles.
To increase stability, the pins themselves have a low center of gravity. Because they are spherical in shape, they can roll and strike other pins in a variety of directions.
The force acting on the bowling ball is friction and air resistance. The friction force is equal to the friction coefficient multiplied by the normal force, and thus mass times acceleration.
Thus, the correct option is A.
For more details regarding magnetism, visit:
https://brainly.com/question/2841288
#SPJ2
A meter stick is attached to one end of a rigid rod with negligible mass of length l = 0.302 m. The other end of the light rod is suspended from a pivot point, as shown in the figure below. The entire system is pulled to a small angle and released from rest. It then begins to oscillate. A meter stick hung from a rod of length l. The rod is attached to the ceiling. The rod and meter stick extend downward in a straight line making a small angle with the vertical. (a) What is the period of oscillation of the system (in s)? (Round your answer to at least three decimal places.)
The period of oscillation of the system nearest to three decimal places
= 1.092 seconds
The period of an oscillation occurring in a system is the time taken to complete one cycle.
The formula that is used to calculate the period of oscillation (T) is
= 2π√[tex]\frac{l}{g}[/tex]
But,
π = 3.14159 (constant)
g= 10m/s² (acceleration due to gravity)
l = 0.302 m
Therefore T = 2 × 3.14159 × √[tex]\frac{0.302}{10}[/tex]
= 6.28318 x √0.0302
= 6.28318 x 0.17378
= 1.09189s
= 1.092 seconds ( to the nearest three decimal places)
Learn more here:
https://brainly.com/question/23752181
A mountain climber encounters a crevasse in an ice field. The opposite side of the crevasse is a height h lower, and is separated horizontally by a distance w. To cross the crevasse, the climber gets a running start and jumps in the horizontal direction. If the height of the crevasse increases but the width remains the same, then,
Select one:
O a. the minimum speed needed to cross the crevasse stays the same.
O b. the minimum speed needed to cross the crevasse will depend on the mass of the mountain climber.
O c. the minimum speed needed to cross the crevasse decreases.
O d. the minimum speed needed to cross the crevasse increases.
O e. the minimum speed needed to cross the crevasse will depend on the weight of the mountain climber.
Which scientist is credited with having the greatest contribution to early microscopy and was the first to observe and describe single-celled organisms?
Answer:
Antonie van Leeuwenhoek
Explanation:
What on earth is equal to 9.8m/s/s
Answer:
Acceleration due to gravity
Option B.
Consider a setup in which two springs are attached to a mass in parallel.
Convince yourself that in this setup, the compression of each spring must be the same. Using
this fact, derive the effective spring constant for springs in parallel
This is asking, "ll1 replace the two springs by a single imaginary spring, what would its spring
constant be such that the force stays the same?" Your answer should only depend on k, and k
Answer:
it would be...
Explanation:
60 POINT!!!!!!
PLEASE HELP THIS WORK IS VERY IMPORTANT FOR ME
IF YOU GIVE ME THE CORRECT ANSWER I WILL GIVE YOU THE CROWN!!
Miranda found four different bottles filled with unknown pure liquids. She measured the mass, volume, and boiling point of these liquids, and calculated the density which are displayed in Table 1.
What conclusion can you make on whether any of the liquids are the same. Explain based on the information in the table.
Answer:
Samples 2 and 4 are the same liquid
Explanation:
Samples 2 and 4 should be the same liquid because they have the same density as well as the same boiling point. The mass and volumes given do not matter in this case, however they could be used to calculate the density which was already given.
The liquid present in sample 2 and 4 is same as according to forces of attraction they have same density and boiling points.
What are forces of attraction?
Forces of attraction is a force by which atoms in a molecule combine. it is basically an attractive force in nature. It can act between an ion and an atom as well.It varies for different states of matter that is solids, liquids and gases.
The forces of attraction are maximum in solids as the molecules present in solid are tightly held while it is minimum in gases as the molecules are far apart . The forces of attraction in liquids is intermediate of solids and gases.
The physical properties such as melting point, boiling point, density are all dependent on forces of attraction which exists in the substances.
Learn more about forces of attraction,here:
https://brainly.com/question/23841038
#SPJ2
 what is the difference between repelling and attracting
Answer:
Attracting means pulling toward you and repelling means pushing away
Explanation:
Answer: Repelling is when something will not connect with another object. The force will cause a repel between the two objects. Attracting is when something is attracted or being pulled to another object.
Explanation: Hope this helps!
Vesta is a minor planet (asteroid) that takes 3.63 years to orbit the Sun.
Calculate the average sun -Vesta distance
Using Kepler's third law, the average sun -Vesta distance is 2.36 AU.
According to Kepler's laws, the square of the period of revolution of planets are proportional to the cube of their average distances from the sun. Hence, we can write; [tex]T^{2} =r^{3}[/tex]
Where;
T = period of the planet
r = average distance of the planet
When;
T = 3.63 years
r = [tex]\sqrt[3]{T^2}[/tex]
r = [tex]\sqrt[3]{(3.63)^2}[/tex]
r = 2.36 AU
Learn more:https://brainly.com/question/14281129
