Answer:
SO₂: 0.39atm
O₂: 3.645atm
Explanation:
Based on the reaction:
2 SO₂(g) + O₂(g) → 2 SO₃(g)
2 moles of sulfur dioxide react per mole of oxygen to produce 2 moles of sulfur trioxide.
When the reaction occurs an comes to equilbrium, the partial pressure of each gas is:
SO₂: 1.3atm - 2X
O₂: 4.1atm -X
SO₃: 2X
Where X is the reaction coordinate.
As pressure at equilibrium of SO₃ is 0.91 atm:
0.91atm = 2X
Thus: X = 0.455atm.
Replacing, pressures at equilibrium of the gases are:
SO₂: 1.3atm - 2×0.455atm = 0.39 atm
O₂: 4.1atm -0.455atm = 3.645 atm
If a solution has a pOH=12, what is its pH?
Answer:
2
Explanation:
pH+pOH=14
- Hope that helps! Please let me know if you need further explanation.
Answer:
2
Explanation:
Ph+PoH=14
18.35 mL of an HCN solution were titrated with 35.4mL of a 0.268M NaOH solution to reach the equivalence point. What is the molarity of the HCN solution
Answer:
0.517
Explanation:
HCN + NaOH → NaCN + H2O [balanced as written]
(35.4 mL) x (0.268 M NaOH) x (1 mol HCN / 1 mol NaOH) / (18.35 mL HCN) = 0.517 M HCN
Answer: 0.517
Explanation:
At constant pressure, what generally happens to the solubility of solids and gases when the temperature of a solution is increased?
A. The solubility of solids and gases increases.
B. The solubility of solids and gases decreases.
C. The solubility of solids increases, and the solubility of gases decreases.
D. The solubility of solids decreases, and the solubility of gases increases.
Answer:
C)
Explanation:
JUST DID IT
Answer:
A D E
Explanation:
just did it
The largest contributed to water pollution is
Answer:
this si from google hope it helps
Explanation:
The Main Causes of Water Pollution in the U.S.
Runoff from Agricultural Operations. Agriculture represents one of the biggest sources of water pollution in the country. ...
Runoff and Nonpoint Source Pollution. ...
Industrial Activities. ...
Leakage from Underground Storage and Piping. ...
Leaking Sewers. ...
Vehicle Emissions. ...
Landfill Leakage. ...
Hazardous Waste.
Answer:
Runoff and Non-point Source Pollution.
Explanation:
it's caused by rainfall or snow-melt moving over and through the ground. As the runoff moves, it picks up and carries away natural and human-made pollutants, finally depositing them into lakes, rivers, wetlands, coastal waters and ground and NPS is it's abbreviation.
A sample of helium gas at room temperature is compressed from 100 cm3 to 20 cm3. Its new pressure is now 30 cm Hg. What was the original pressure of the gas?
Answer:
6 cm Hg
Explanation:
Boyles Law: P1V1=P2V2
(100 mL)(x)=(20 mL)(30 cm Hg)
x = 6 cm Hg
*Text me at 561-400-5105 for private tutoring if interested: I can do homework, labs, and other assignments :)
4. A taxi ride costs $5 plus .75 cents per mile. If I
ride for 120 miles, how much will be charged?
Answer:
$95
Explanation:
.75 x 120 = 90
90+5 = 95
Two identical light bulbs are connected to a battery in a series circuit.
An ammeter is wired into the circuit at measures a current of the
battery to be 0.5 Amps. The two light bulbs are then wired in parallel.
The ammeter shows that the current:
Answer:
0.10 amps
Explanation:
At what temperature will a gas be, if you allow it to expand from its original volume of 756 mL at 65.0 °C to 1.40 L? (hint volume needs to be the same)
Answer:
120.4 gradius Celcius
Explanation:
Please see the step-by-step solution in the picture attached below.
Hope this answer can help you. Have a nice day!
How to make isopropyl alcohol
Answer:
.It is easily synthesized from the reaction of propylene with sulfuric acid, followed by hydrolysis. Isopropyl alcohol (2-propanol) is made by indirect hydration of propylene (CH2CHCH3).… In some cases the hydration of propylene is carried out in one step, using water and a catalyst at high pressure.
Hope it'll help!
stay safe:)
What are 3 stages of the water cycle are
What is the molar mass of ethanol (C2H60)?
Answer:
46.07 g/mol is the molar mass of ethonal
What is the molarity of sodium hydroxide solution made by combining 2.0 L of 0.60
NaOH With 495 mL 3.0 M NaOH? Assume the volumes of the two solutions to be additive___M
Answer:
[tex]M=1.1M[/tex]
Explanation:
Hello,
In this case, since we are mixing two NaOH solutions, the first step is to compute the total moles once the mixing is done, by using the volumes and concentrations of each solutions and subsequently adding them:
[tex]n_T=2.0L*0.60\frac{mol}{L}+495mL*\frac{1L}{1000mL}*3.0\frac{mol}{L}= 2.7molNaOH[/tex]
Next, we compute the total volume by adding the volume of each solution:
[tex]V_T=2.0L+495mL*\frac{1L}{1000mL}= 2.495L[/tex]
Finally, we compute the molarity of the resulting solution by the division between the total moles and the total volume:
[tex]M=\frac{2.7mol}{2.495L}\\ \\M=1.1M[/tex]
Best regards.
How many moles
are equal to
4.11x1023
molecules of
CO2?
Explanation:
6.02×1023 culture atoms have a mass of 63.5g. 12.0g. c +23.0g O2__44.0g CO2.(12.0+16.0+16.0=44.0g).1 mol 1 mol. 1 mol number molecules weight
The number of molecules in one mole of carbon dioxide is 6.02 × 10²³. Therefore, the number of moles of carbon dioxide which contains 4.11 × 10²³ molecules is 0.68.
What is Avogadro number ?The number of atoms that constitutes one mole of a substance is called Avogadro number. It is equal to 6.02 × 10²³. Thus, one mole of every elements contains Avogadro number of atoms.
Similarly, one mole of a compound contains 6.02 × 10²³ number of molecules. Thus, one mole of carbon dioxide contains these much molecules.
Given the number of molecules of carbon dioxide = 4.11 × 10²³
Then, no.of moles = number of molecules/ Avogadro number.
no.of moles = 4.11 × 10²³ /6.022 × 10²³ = 0.68.
Therefore, the number of moles of CO₂ that contains 4.11 × 10²³ molecules is 0.68.
Find more on Avogadro number:
https://brainly.com/question/28834341
#SPJ5
The change in entropy, ΔS∘rxn , is related to the the change in the number of moles of gas molecules, Δngas . Determine the change in the moles of gas for each of the reactions and decide if the entropy increases, decreases, or has little or no change. A. 2H2(g)+O2(g) ⟶ 2H2O(l) Δngas= mol The entropy, ΔS∘rxn , increases. decreases. has little or no change.
Explanation:
Entropy of a reaction ΔS∘rxn is the degree of disoderliness in a system. Gases generally have a higher degree of disorder compared to liquids. Hence for the reaction 2H2(g)+O2(g) ⟶ 2H2O(l), the entropy decreases sice the reactants are in the gaseous state and the products is in the liquid state of matter
If you start with 64g of a radioactive element how many half-lives would occur before 8g remain?
Answer:
3 half-lives
Explanation:
The half-life is the time that it takes to a radioactive element to decay to half of its initial amount.
Let's suppose we start with 64 g of the radioactive element.
After 1 half-life, the mass of the element will be 32 g.After 2 half-lives, the mass of the element will be 16 g.After 3 half-lives, the mass of the element will be 8 g.What is the hydronium ion concentration of a 0.100 M acetic acid solution with Ka = 1.8 × 10-5? The equation for the dissociation of acetic acid is: CH3CO2H(aq) + H2O(l) ⇌ H3O+(aq) + CH3CO2-(aq) What is the hydronium ion concentration of a 0.100 M acetic acid solution with Ka = 1.8 × 10-5? The equation for the dissociation of acetic acid is: CH3CO2H(aq) + H2O(l) ⇌ H3O+(aq) + CH3CO2-(aq) 1.3 × 10-2 M 4.2 × 10-2 M 1.3 × 10-3 M 4.2 × 10-3 M
Answer:
1.3×10⁻³ M
Explanation:
Hello,
In this case, given the dissociation reaction of acetic acid:
[tex]CH_3CO_2H(aq) + H_2O(l) \rightleftharpoons H_3O^+(aq) + CH_3CO_2^-(aq)[/tex]
We can write the law of mass action for it:
[tex]Ka=\frac{[H_3O^+][CH_3CO_2^-]}{[CH_3CO_2H]}[/tex]
Of course, excluding the water as heterogeneous substances are not included. Then, in terms of the change [tex]x[/tex] due to the dissociation extent, we are able to rewrite it as shown below:
[tex]1.8x10^{-5}=\frac{x*x}{0.100-x}[/tex]
Thus, via the quadratic equation or solve, we obtain the following solutions:
[tex]x_1=-0.00135M\\x_2=0.00133M[/tex]
Obviously, the solution is 0.00133M which match with the hydronium concentration, thus, answer is: 1.3×10⁻³ M in scientific notation.
Regards.
Answer:
1.3×10^-3 M
Explanation:
Step 1:
Data obtained from the question:
Equilibrium constant (Ka) = 1.8×10^-5
Concentration of acetic acid, [CH3COOH] = 0.100 M
Concentration of hydronium ion, [H3O+] =..?
Step 2:
The balanced equation for the reaction.
CH3CO2H(aq) + H2O(l) ⇌ H3O+(aq) + CH3CO2-(aq)
Step 3:
Determination of concentration of hydronium ion, [H3O+].
This can be obtained as follow:
Ka = [H3O+] [CH3CO2-] / [CH3CO2H]
Initial concentration:
[CH3COOH] = 0.100 M
[H3O+] = 0
[CH3CO2-] = 0
During reaction
[CH3COOH] = – y
[H3O+] = +y
[CH3CO2-] = +y
Equilibrium:
[CH3COOH] = 0.1 – y
[H3O+] = y
[CH3CO2-] = y
Ka = [H3O+] [CH3CO2-] / [CH3CO2H]
1.8×10^-5 = y × y / 0.1
Cross multiply
y^2 = 1.8×10^-5 x 0.1
Take the square root of both side
y = √(1.8×10^-5 x 0.1)
y = 1.3×10^-3 M
[H3O+] = y = 1.3×10^-3 M
Therefore, the concentration of the hydronium ion, [H3O+] is 1.3×10^-3 M
What is the mass defect of a mole of nuclei with 1.8 x 10^15 J/mol binding
energy?
Answer:
2.0 x 10^-2 kg/mol
Explanation:
Which diagram correctly describes the changes that occur as a small piece of rock falls from space and hits the earth
Answer:
the motion of gravity
Explanation:
Answer:
its c
Explanation
advhuosijoklxcmnjdabsuhggggabciaciudeifweingivg eygerigsygfe97rsghisdcvhbsduigwiugfu9uigdgiurfgyisdgfsdgfegiygewifgsdygfewusgfuyesigf7wgfiesgfiusgdfies
The glass of a lit 75-watt incandescent bulb is hotter to the touch than the glass of a 25-watt compact fluorescent (CFL) bulb that emits the same amount of light. What could be a reason for this
HELP PLEASE ILL GIVE 25 pointsWhich of the following practices could help reduce erosion of water banks? a. buffer strips b. natural fertilizers and pesticides c. decrease in fossil fuel emissions d. all of the above Please select the best answer from the choices provided A B C D
Answer:
A. Buffer strips
Explanation:
The practice that could help reduce erosion of water banks is buffer strips.
What is erosion?Erosion is the action of surface processes that removes soil, rock or dissolved material from one location on the Earth's crust, and then transports it to another location where it is deposited.
One of the practices that could be used to reduce the effect of erosion is buffer strips.
What buffer strips do is slow and filter storm runoff while helping to hold soil in place.
Learn more on buffer strips here; https://brainly.com/question/26872640
