(NEED HELP IMMEDIATELY) In a gene, which base sequence codes for two amino acids?
1. CTAA
2. AG
3. GAGCTC
4. GAA

Answer:

The answer is HSO4- is a weak acid which will be C

The acid dissociation constant, ka, of HSO4- indicates that it is a strong acid. Details about acid dissociation constant can be found below.

The acid dissociation constant denoted by Ka is the measure of the strength of an acid.

The dissociation constant of an acid is used to identify strong acids from their weak counterparts. Strong acids have high Ka values while weak acids have low Ka values.

According to this question, the Ka of HSO4- is 1.2 × 10-², which is quite high.

Therefore, the dissociation constant, ka, of HSO4- suggests that it is a strong acid.

Learn more about acid dissociation constant at: https://brainly.com/question/4363472

#SPJ9

Answer:

carbon reaction with iron from its oxide. Why?? Because it is largely used in extraction of metals. It is used in acid indigestion.

Answer:

A. 70 K

B. 3.16 atm

Explanation:

We'll begin by calculating the number of mole in 175 g of Ar. This can be obtained as follow:

Mass of Ar = 175 g

Molar mass of Ar = 40 g/mol

Mole of Ar =?

Mole = mass / molar mass

Mole of Ar = 175 / 40

Mole of Ar = 4.375 moles

A. Determination of the temperature.

Mole of Ar (n) = 4.375 moles

Volume (V) = 2.50 L

Pressure (P) = 10 atm

Gas constant (R) = 0.0821 atm.L/Kmol

Temperature (T) =?

PV = nRT

10 × 2.5 = 4.375 × 0.0821 × T

25 = 4.375 × 0.0821 × T

Divide both side by (4.375 × 0.0821)

T = 25 / (4.375 × 0.0821)

T ≈ 70 K

B. Determination of the pressure.

Mole of Ar (n) = 4.375 moles

Volume (V) = 2.50 L

Temperature (T) = 22 K

Gas constant (R) = 0.0821 atm.L/Kmol

Pressure (P) =?

PV = nRT

P × 2.5 = 4.375 × 0.0821 × 22

Divide both side by 2.5

P = (4.375 × 0.0821 × 22) / 2.5

P = 3.16 atm.

Answer:

D

Explanation:

B is solid and liquid while D is liquid and gas

Answer:

Option ( D) is correct

The phase transition occurs at 100o C (the normal boiling point of water). Liquid water becomes water vapor or steam when it enters the gaseous phase.

Explanation:

A heating curve graphically represents the phase transitions that a substance undergoes as heat is added to it.

The liquid will begin to boil when enough heat has been absorbed by the solution that the temperature reaches the boiling point, where again, the temperature remains constant until all of the liquid has become gaseous water. At the atmospheric pressure of 1 atm, this phase transition occurs at 100o C (the normal boiling point of water). Liquid water becomes water vapor or steam when it enters the gaseous phase. Use the heat of vaporization ([latex]\Delta H_{vap}[/latex] ) to calculate how much heat was absorbed in this process: [latex]q=m\cdot C_{H_2O(g)}\cdot \Delta T[/latex], where m is the mass of the sample of water.

After all of the liquid has been converted to gas, the temperature will continue to increase as heat as added. Again, the heat added that results in a certain change temperature is given by: [latex]q=m\cdot C_{H_2O(g)}\cdot \Delta T[/latex] . Note that the specific heat capacity of gaseous water is different than that of ice or liquid water.

The answer is ‘Passive Transport’

movement of molecules without the use of energy is due to the shrinkage of water

Answer:

Mg

Explanation:

Mg forms 2+ ions and mgcl2 has a melting point over 700°C I believe.

Answer:

NAO SRESONDEPORR PQUEOU BUOBRRRA  IGAD THCAAUSEI

Explanation:

Answer:

C. Enlargement

Explanation:

Answer:

Phosphorus atoms can bond with oxygen atoms to form ester groups. These can bond with carbon atoms, yielding a large number of organic phosphorus chemicals. These are found in many important biological processes

Answer:

Option A:

Zn(s) + Cu^(2+) (aq) → Cu(s) + Zn^(2+)(aq)

Explanation:

The half reactions given are:

Zn(s) → Zn^(2+)(aq) + 2e^(-)

Cu^(2+) (aq) + 2e^(-) → Cu(s)

From the given half reactions, we can see that in the first one, Zn undergoes oxidation to produce Zn^(2+).

While in the second half reaction, Cu^(2+) is reduced to Cu.

Thus, for the overall reaction, we will add both half reactions to get;

Zn(s) + Cu^(2+) (aq) + 2e^(-) → Cu(s) + Zn^(2+)(aq) + 2e^(-)

2e^(-) will cancel out to give us;

Zn(s) + Cu^(2+) (aq) → Cu(s) + Zn^(2+)(aq)

Answer: It’s 4.0

Explanation: I just took the test and got it right:)

Answer:

the atomicity of sulphur is 8

Explanation:

hope it helps

Answer:

answer is in the picture.

Answer:

a. B

b. C

c. A

d. A

e. B

f. -266

g. B and D

Answer:

I think option (d) is right answer

Answer:

I think that the answer is option(C)

Answer:

I would guess more atoms? but there is no graph attached

Answer:

A balanced chemical equation must always include coefficients on every reactant and product.

Explanation:

A balanced chemical equation does not need to include coefficients on every reactant and product.

For example, below is a balanced chemical equation in which the reactants and the products have no coefficients whatsoever:

NaOH(aq) + HCl (aq) -----> NaCl (s) + H2O (l)

Of course, a properly written chemical equation must include the states of matter of all the substances in the reaction and the number of atoms of each element must balance both in the reactant and product sides of the equation. Generally, a balanced chemical equation must obey the law of conservation of matter which opines that matter can neither be created nor destroyed but can only be converted from one form to another.

Hence, that a balanced chemical equation must always include coefficients on every reactant and product is not true.

Answer:

Ba

Explanation:

Answer:

1s2 2s2 2p6 3s2 3p6

Explanation:

Chlorine is a groups 17 element. The halogens for ions by accepting one electron to form univalent negative ions.

Since chlorine normally contains seventeen electrons, the chloride ion consists of eighteen electrons.

Hence the electronic configuration of chlorine ion is; 1s2 2s2 2p6 3s2 3p6.

An air mass is a volume of air whose temperature and humidity are specified. Many hundreds or thousands of square miles are covered by air masses, which adjust to the properties of the land underneath them.

An air mass is a volume of air whose temperature and humidity are specified. Many hundreds or thousands of square miles are covered by air masses, which adjust to the properties of the land underneath them. Latitude and their continental or marine source regions are used to categorize them.

There is a temperature and air pressure differential. Storms are caused by abrupt changes in the weather. Two natural wind patterns come into conflict.

The hot and dry continental tropical (cT) air mass is prevalent over subtropical and tropical continents. The world's largest deserts, such the Sahara, Arabian, and Australian, are important source areas.

Thus, Latitude and their continental or marine source regions are used to categorize them. An air mass is a volume of air whose temperature and humidity are specified.

To learn more about an air mass, follow the link;

https://brainly.com/question/28709357

#SPJ2

Answer:

1 Ca(OH)2 + 2 HCl ---> 1 CaCl2 + 2 H2O

Answer:

answer of your question is 4th

Explanation:

P205

Answer:

CO32-(aq) + 2H+(aq) → CO2(g) + H2O(l)

Explanation:

According to this question, sodium carbonate reacts with sulfuric acid to form aqueous sodium sulfate, carbon dioxide and water. The balanced chemical equation is as follows:

Na2CO3(aq) + H2SO4(aq) → Na2SO4(aq) + CO2(g) + H2O(l)

- Next, split compounds that are aqueous into ions.

2Na+(aq) + CO32-(aq) + 2H+(aq) + SO42-(aq) → 2Na+(aq) + SO42-(aq) + CO2(g) + H2O(l)

- Next, we cancel out the spectator ions, which are ions that remain the same in the reactants and products side of a chemical reaction. The spectator ions in this equation are 2Na+(aq) and SO42-(aq).

CO32-(aq) + 2H+(aq) → CO2(g) + H2O(l)

- Hence, the balanced ionic equation is as follows:

CO32-(aq) + 2H+(aq) → CO2(g) + H2O(l)

Answer:

see explanation

Explanation:

Solutions are prepared from one of three solute sources ...

- solid solute from manufacturer,

-liquid solute from manufacturer,

-stock concentrate of solute for dilution to lower concentrations.

In this problem, sucrose is a stock solid with a formula mass of 342.3 grams/mol. The amount of solid needed can be determined using the formula:

mass of solute needed (grams) = (Molarity needed x Volume needed in Liters x formula weight) / (decimal fraction purity of stock solid)

Molarity needed = 0.3M

Volume needed = 500 ml = 0.500 liters

Formula weight = 342.3 grams/mole

Purity factor (assumed) = 100% = 1.00 (should be posted on stock bottle label) For example, a 95% pure stock solid => purity factor of 0.95.

∴ grams of sucrose needed = (0.3M*)(0.500L)(342.3g/mole)/(1.00) =51.345 grams sucrose.

Measure 51.345 grams of sucrose into mixing vessel and add solvent water up to, but not to exceed 500 ml total volume. Mix until homogeneous.

Answer:

This is because Mendeleev arranged the elements in order of increasing relative atomic mass.

Explanation:

Dmitri Mendeleev is one of the scientists that contributed to the development of periodic table in chemistry. He was able to organise elements into rows according to their atomic mass and into columns based on chemical and physical properties. This is the main reason why his periodic table is still studied even though it has some defects which include:

--> Grouping of elements that are not similar chemically: For example Copper and Silver bear no resemblance with the alkali metals, but they have been placed together in the first group.

--> Position of isotopes: According to his periodic table: Isotopes of an element must be given separate places in the periodic table because they have different atomic masses.

--> Electronic arrangement of elements: It failed to explain the electronic arrangement of elements.

--> Separation of chemically similar elements:

Elements that are chemically similar such as Gold and Platinum have been placed in separate groups.

Answer:

fe oo andffffe

aiejand iefjwe

eekkfwefwe f

opw fwfwfew

efefwefwefwi

Explanation:

Answer:

ii and iv

Explanation:

atomic mass is the sum of protons and neutrons

protons ( postively charged) usually have the same number like electrons( negatively charged)