Describe 5 importance matter to undergo changes​

Answer:

See explanation

Explanation:

For a chemical system in a state of dynamic equilibrium, the rate of forward reaction is equal to the rate of reverse reaction.

For this system under consideration;

I2(s)⇄I2(g)

When we heat the container, solid iodine is converted into purple coloured iodine vapour.

When equilibrium is achieved in the system, there will be no net change in the amount of solid iodine and iodine vapour present in the system since the rate of forward and reverse reactions are equal for a system in a state of equilibrium.

where is the directions here?

I cannot answer this if no directions

Answer:

silicon and germanium.

Explanation :

The passage states that at extreme pressures an elemental solid assumes the structure and bonding characteristics of a heavier element in the same column of the periodic table. The structure and bonding of diamond, which is a form of carbon, would therefore be most like other elements in the same group of the periodic table as carbon. This group contains silicon and germanium.

Answer: Dont let the water get inside your private area because it can lead to you washing out the healthy bacteria in your private area !

Explanation:

Also dont do it because you dont know if your water is clean enough for that ..

Answer:

is the water that passes through the carbon cycle of atmosphere

Answer:

a scientific question

Procedure

Conclusion.

Explanation:

Scientific investigation is usually carried out to explain and give answers to natural phenomenon. Now, this scientific investigation is performed through the three main types as described in the question.

With that being said, the most common parts of all types of investigation are :

1. Scientific question: In this stage, questions are usually asked on the basis of observation made which could be answered.

2. Procedure: In this stage, the dimension of the steps are followed to answer and test the scientific question.

3. Conclusion: This is the primary aim that we check when done with our sample values

Answer:

huh what?

Explanation:

Is  196,96657  u

I hope I've helped :)

Answer:

O 100

Explanation:

Answer:

Longer

Explanation:

:)

Answer:

Final pressure, P2 = 1088.89 atm

Explanation:

Given the following data;

Initial volume, V1 = 725 cm³

Initial temperature, T1 = 30°C

Initial pressure, P1 = 1.19 atm

Final volume, V2 = 1.12 cm³

Final temperature, T2 = 43°C

To find the final pressure (P2), we would use the combined gas law.

Mathematically, the combined gas law is given by the formula;

[tex] \frac {PV}{T} = k [/tex]

[tex] \frac {P_{1}V_{1}}{T_{1}} = \frac {P_{2}V_{2}}{T_{2}} [/tex]

Substituting into the formula, we have;

[tex] \frac {1.19*715}{30} = \frac {P_{2}*1.12}{43} [/tex]

[tex] \frac {850.85}{30} = \frac {P_{2}*1.12}{43} [/tex]

[tex] 28.3617 = \frac {P_{2}*1.12}{43} [/tex]

Cross-multiplying, we have;

[tex] 28.3617 * 43 = 1.12P_{2} [/tex]

[tex] 1219.5531 = 1.12P_{2} [/tex]

[tex] P_{2} = \frac {1219.5531}{1.12} [/tex]

Final pressure, P2 = 1088.89 atm

Answer:

uh i think this is the answer

Explanation:

D. The empirical formula and the molar mass

Explanation:

If the iceberg is near the lake and the water molecules melt, then the molecules will slide down. The iceberg could be melting for many reasons - it can be purposely destroyed, the sun could be melting it, or it might naturally fall in. So, this is the answer to your question. Hope it helps!

Answer:

A

Explanation:

I think that is the ans but am not sure

Answer:

2-methylpropan-1-ol.

Explanation:

[tex]{ \tt{CH _{3}CH(CH _{3})CH _{2}OH}}[/tex]

Answer:

highly concentrated solution of acid

Answer:

C = m/V

Explanation:

In order to calculate the concentration of a mixture you would need to use the formula for concentration, which is the following...

C = m/V

In this formula C is the concentration, m is the mass of the compound that is being added and mixed into the solution, and V is the total volume of the mixture. The mass of m is in terms of number of moles. Therefore, we would need more information in order to calculate the actual concentration of the mixture that you are trying to find in this scenario. Using the formula above should be enough using the values that you have in your actual workbook.

Answer:

a. 1 cm^3 = 1 mL

explanation:

Answer: The molarity of 198 g of barium iodide [tex](BaI_{2})[/tex] in 2.0 L of solution is 0.253 M.

Explanation:

Given: Mass = 198 g

Volume = 2.0 L

Molarity is the number of moles of solute present in liter of a solution.

Moles is the mass of a substance divided by its molar mass. So, moles of barium iodide (molar mass = 391.136 g/mol) is calculated as follows.

[tex]Moles = \frac{mass}{molar mass}\\= \frac{198 g}{391.136 g/mol}\\= 0.506 mol[/tex]

Now, molarity is calculated as follows.

[tex]Molarity = \frac{moles}{Volume (in L)}\\= \frac{0.506 mol}{2.0 L}\\= 0.253 M[/tex]

Thus, we can conclude that the molarity of 198 g of barium iodide [tex](BaI_{2})[/tex] in 2.0 L of solution is 0.253 M.

Answer:

For the first question, to determine the total number of molecules of nitrogen dioxide, first make use of the molar mass of the nonpolar compound and then use that to find the total number of moles and then subsequently after make use of the ratio for the Avogadro's number to determine the total number of molecules of this compound.

For the final question, do the inverse, where we make use of the molecules of the compound and then use Avogadro's number to determine the moles of the compound and then use the same molar mass of the compound to determine the grams of the Nitrogen Dioxide.

Answer:

0.241 M

Explanation:

We'll begin by writing the balanced equation for the reaction. This is given below:

HBr + NaOH —> NaBr + H₂O

From the balanced equation above,

The mole ratio of acid, HBr (nₐ) = 1

The mole ratio of base, NaOH (n₆) = 1

Finally, we shall determine the concentration of the NaOH solution. This can be obtained as follow:

Volume of base, NaOH (V₆) = 20 mL

Volume of acid, HBr (Vₐ) = 24.1 mL

Concentration of acid, HBr (Cₐ) = 0.2 M

Concentration of base, NaOH (C₆) =?

CₐVₐ / C₆V₆ = nₐ/n₆

0.2 × 24.1 / C₆ × 20 = 1/1

4.82 / C₆ × 20 = 1

Cross multiply

C₆ × 20 = 4.82

Divide both side by 20

C₆ = 4.82 / 20

C₆ = 0.241 M

Therefore, the concentration of the NaOH solution is 0.241 M

Answer:

Chemical potential energy being converted to kinetic energy

Explanation:

Answer:

La electrólisis es un proceso físico por el que se descompone una sustancia en disolución a través de la corriente eléctrica. Para que la electrólisis sea posible es necesaria una fuente de alimentación continua, una disolución iónica y dos polos (ánodo y cátodo), que atraen hacia sí los iones de signo opuesto.

Answer:

VSEPR theory

Explanation:

The valence shell electron pair repulsion theory was propounded by Gillespie and Nylom (1957).

The entire idea of the VSEPR theory is that the shape of a molecule depends on the electrostatic repulsion between electron pairs surrounding the central atom in a molecule which causes these pairs to be separated as far as possible.

The shapes of many molecules can be accurately predicted based on this model.

Answer:

Hi!

chemistry;

unlike others, is more about atomic structure.

HAVE A NİCE DAY

Explanation:

GREETİNGS FROM TURKEY ツ

Answer:

CHEMISTRY means the study of matter and the different chemical reactions that any substance goes through, like, matters composition, structure, shape, state, etc. while geology, biology and physics are the other branches of science and chemistry acts as a bridge between physics and geology with biology.

hope it helps

have a nice day

Answer:

use this formula it will help u .

Explanation:

If 60 ml of ethanol is diluted to a final volume of 400 ml, you create a 35 % ethanol solution.

First, realize that you creating a solution with that contains a polar solute (ethanol) with a polar solvent (water). Remember that "like dissolves like."

If you pour 60 ml of ethanol in a volumetric flask, you add 340 ml of water to dilute this solution to a final volume of 400 ml.

Volumetric flasks are designed to make or dilute solutions to specified final volume.

Since you have 60 ml of ethanol in a total solution of 400 ml, the percentage of ethanol is 35 %.

This result is obtained in the following manner.

ml/400. ml. = .35

.35 x 100% = 35 %

Explanation:

Oceans can influence weather and climate. For example, cities located near large water bodies like oceans tend not to have extreme climates

Answer;

P4O10 - molecular solid

Graphite - network solid

Ammonium phosphate - ionic

Brass - metallic

SiC - network solid

Rb- metallic

I2 - molecular

LiBr- ionic

P4 - molecular

Plastic - amorphous

Si - network

Explanation:

An ioinc solid is made up of a pair of oppositely charged ion held together by electrostatic interaction between the bonding species.

A covalent solid is a solid in which the atoms involved in the solid are bonded together by covalent bonds. Covalent solids are also molecular.

Metals are held together by interaction of metal ions and a sea of electrons. This is called the metallic bond.

A network solid is composed of covalently bonded atoms that repeat itself in a definite manner. E.g SiC

Answer:

a

Explanation:

Its because ammonium has thee hydrogen atoms