Explanation:
Aight, I'mma give tell ya an easy way for this question. look at this Forumla
M=
[tex] \frac{10ad}{m} [/tex]
a explains the percentage of aqueous solution
d is the density
m is the molar mass
right, let's just hop to it
M=10×28×1.25/11.5====> M=30.43
which of the following has more atoms 3.14 g Cu or 1.10 g of H? Explain
Water is dipolar because:
A. It has two hydrogens, each of which pulls oxygen's electrons and separates the
charges into two areas.
B. Oxygen pulls electrons closer to itself than hydrogens, giving the oxygen a
slight negative and hydrogens a slight positive charge.
C. Oxygen pulls electrons closer to itself than hydrogens, giving the oxygen a
slight positive and hydrogens a slight negative charge.
OD. It has two hydrogens, each of which has its own polar area.
Answer:
B. Oxygen pulls electrons closer to itself than hydrogens, giving the oxygen a slight negative and hydrogens a slight positive charge.
Explanation:
In the water molecule (H2O), an oxygen atom is bonded to two hydrogen atoms. Oxygen atom is much more electronegative (has more attraction for electrons) than hydrogen atom, hence, it pulls electrons from one one of the hydrogen atoms bonded to it making it more negatively charged and the hydrogen atom, more positively charged.
The possession of positive charge (+) and negative charge (-) in the same molecule, caused by uneven flow of electrons is what it means to be DIPOLAR (from dipole). Hence, water is DIPOLAR because oxygen pulls electrons closer to itself than hydrogens, giving the oxygen a slight negative and hydrogens a slight positive charge.
What is the electron configuration for fluorine?
Answer:
1s2 2s2 2p5
step by step:
Answer:
Electron configuration using subshell;
1s² 2s² 2p⁵
using main shell ie;
2,7
Infrared waves are an example of heat transfer by
A. convection
B. radiation
C. conduction
D. motion of the air
Answer:
convection is my correct answer
A report on the various water conservation methods used by any one
states of India
Answer:
Kuls are diversion channels that carry water from a glacier to village. Often spanning long distances, with some over 10 km long, kuls have been around for centuries. They are the lifeline of people of Spiti valley of Himachal Pradesh and in Jammu too.
Kul starts at the glacier, which is to be tapped. Keeping the head clear of debris is achieved by lining the sides of Kul with stones which ensure that there is no seepage or clogging. The Kul leads to the village where the water is stored in a circular water tank. The water is drawn from here are per the need of the village.
Explanation:
Here is a list of some of the traditional water conservation methods that are still in use:
2 Figure 3.1 shows two different forms of carbon, A and B.
A
B
Figure 3.1
a Name the two forms of carbon shown.
Answer:
show the pictures pls specify
what effect does smiling on at teacher mean when given no homework mean please give me an answer thanks guys
Answer:
no n o n o n o nonono in o no n o n I n jo n b
Explanation:
no no no no no no n on on on I I j
To convert from one metric unit to another metric unit is done simply by moving the decimal place the appropriate amount of places.
Example: 2.5 cm = 25 mm
true or false?
Answer: true
Explanation:
2.5 cm does = 25mm
Answer:
True
Because, all of these metric units differ from one another by a multiple of 10.
Which of the following has maximum number of atoms?
(a) 18 g of H2O
(b) 18 g of O2
(c) 18 g of CO2
(d) 18 g of CO4
Answer:
(a) 18 g of H2O
Explanation:
The molecule with great number of moles will have great number of atoms.
By observation, since all compounds have same mass, water has the least molcular mass
[tex]H_{2} O = \: 18 \: g[/tex]
Answer:
18g of H2O
Explanation:
the molecule with great number of moles will have great number of atoms .
(a) option is correct
What Chemicals including in Cosmetic?
The chemicals including in cosmetic are:-
1.Talcum Powder
2.Nanoparticles
3.Coal Tar
4.Triclosan
5.Toluene
Hope this helps you.
Which atom is abundant on earth
Answer:
Oxygen
Explanation:
Oxygen is abundant on earth
solution is an example of______mixtures
Answer:
homogeneous mixture must be the answer
calculate the mass of magnesium needed to make 25g of magnesium oxide
Explanation:
here's the answer to your question about
why scientist use the international system of units
Explanation:
it allows scientists from disparate regions to use a single standard in communicating scientific data without vocabulary confusion.
Balance in basic solution: O2(g) + Cr³+ (aq) → H₂O2 (1) + Cr₂O7²- (aq)
cr2o72+H2o2-(r3+o2)
Explanation:
r62o72+H2o2-(r3+o2)
2.
In photosynthesis, which substances are used up, which are produced and which are necessary
but remain unchanged after the reaction?
used up
produced
remain
A
carbon dioxide
water
oxygen
A
8
chlorophylt
carbon dioxide
water
с
oxygen
starch
cellulose
D
water
oxygen
chlorophyll
D. Water is used up, Oxygen is produced and Chlorophyll is necessary, but remains unchanged.
Molar mass calculation for Cl^2
Answer:
Mass of Cl = 35.5
Mass of Cl2 => 35.5×2
=> 71 g/mol
hope that helps ✌
71
explain:The atomic mass of chlorine is equal to the molar mass of chlorine so the molar mass of chlorine is 35.5
=> molar mass for Cl^2: 35,5*2=71
Consider two gases, A and B, which are in a container at room temperature. What effect will the following changes have on the rate of the reaction between these gases?
The temperature is decreased at a constant volume.
A. Increase
B. Decrease
Answer:
A. The rate of reaction will increase or go up
B. The rate of reaction will decrase or go down.
Explanation:
Increasing the temperature will make the gas particles move faster. Faster movement will increase rate of collision between particles to cause a reaction. Decreasing the temperature will cause the opposite to happen.
While driving her car on a hot sunny day, a woman was struck in the back of the neck by the dough from an exploding can of Pillsbury biscuits. From the sound it made and the feeling of warm sticky dough on her neck, she thought she had been hit by a bullet! Describe the likely conditions that caused this to happen. Be sure to explain AT THE MICRO scale how the particles were affected.
Answer:
The dough is made from flour sugar, baking soda, sometimes yeast. The sugar is converted into gaseous products including carbon dioxide, CO₂ and alcohols. As more gases are produced, the pressure increases, and according to Charles's law, as the temperature on a sunny day is higher than on a cool day, the pressure of the gases increases further, to the point that the can containing the biscuits can not hold the pressure, leading to an explosion
Explanation:
step by step of how to convert fahrenheit and celsius to kelvins -5F to kelvins please and thank you
The volume of a gas was 48 mL when the temperature was 159.6 ºC. If the temperature was initially 4.9 ºC, and there was no change in the pressure, what was the initial volume of the gas?
According to Charles law
[tex]\boxed{\sf \dfrac{V_1}{T_1}=\dfrac{V_2}{T_2}}[/tex]
[tex]\\ \sf\longmapsto \dfrac{48}{159.6}=\dfrac{V_2}{4.9}[/tex]
[tex]\\ \sf\longmapsto V_2=\dfrac{48\times 4.9}{159.6}[/tex]
[tex]\\ \sf\longmapsto V_2=\dfrac{235.2}{159.6}[/tex]
[tex]\\ \sf\longmapsto V_2=1.4mL[/tex]
Question 2: thanks!!!
b. What chemist finds
out how much nitrogen is in a sample of air
Which statement is true?
1. Heat refers to a process.
2. Thermal energy refers to a process.
3. Thermal energy refers to a single particle.
4. Heat refers to a quantity.
Answer:
4. Heart refers to a quantity
Answer:
Heat Refers To A Process
how can you identify if a physical or chemical change has occurred
Answer:
The difference between a physical reaction and a chemical reaction is what its made of. In a chemical reaction, there is a change in the materials of the substances in question; in a physical change there is a difference in the appearance, smell, or simple display of a sample of matter without a change in composition. Whereas will a chemical change there is not.
Answer:
Answer:
Physical changes are changes affecting the form of a chemical substance, but not its chemical composition. Physical changes are used to separate mixtures into their component compounds, but can not usually be used to separate compounds into chemical elements or simpler compounds. Chemical changes occur when a substance combines with another to form a new substance, called chemical synthesis or, alternatively, chemical decomposition into two or more different substances. These processes are called chemical reactions and, in general, are not reversible except by further chemical reactions. Some signs of a chemical change are a change in color and the formation of bubbles. The five conditions of chemical change: color chage, formation of a precipitate, formation of a gas, odor change, temperature change. Change in Color. Noticeable Odor (after reaction has begun) Formation of a Precipitate. Formation of Bubbles. Physical changes are changes that do not alter the identity of a substance. Chemical changes are changes that occur when one substance is turned into another substance. Chemical changes are frequently harder to reverse than physical changes
Explanation:
aluminum hydroxide molecular weight step by ste
Please tell me the answer of what is unit?
Answer:
a quantity chosen as a standard in terms of which other quantities may be expressed.
Explanation:
Explanation:
Unit is a standard physical quantity defined and adopted by convention,with other quantity of same kind.
what is the balanced equation of 2HCl + Mg - MgCla + Ha
2HCl + Mg => MgCl2 + H2
Determine the mass of oxygen in a 45.0 g sample of calcium carbonate
Answer:
The mass of oxygen in 45.0 g sample of calcium carbonate is approximately 21.58 g
Explanation:
The chemical formula for calcium carbonate is CaCO₃
The molar mass of CaCO₃ = 100.0869 g/mol
The mass of oxygen in one mole of CaCO₃ = 3 × 15.999 g = 47.997 g
The mass of oxygen in 45.0 g sample of CaCO₃, m, is goven as follows;
m = 45.0/100.0869 × 47.997 g ≈ 21.58 g
The mass of oxygen in 45.0 g sample of calcium carbonate, m ≈ 21.58 g
list from soft to hard
List the following minerals in order from softest to hardest:
apatite, calcite, talc, quartz, diamond.
