Answer:
[tex]\quad[/tex]0.0095 m/s²
Explanation:
We have,
Initial velocity (u) = 32.7 m/sFinal velocity (v) = 44.7 m/sDistance travelled (s) = 48500 mWe are asked to calculate the airplane's acceleration.
By using the third equation of motion,
➝ v² - u² = 2as
v denotes final velocityu denotes initial velocitya denotes accelerations denotes distance➝ (44.7)² - (32.7)² = 2 × a × 48500
➝ 1998.09 - 1069.29 = 97000 × a
➝ 928.8 = 97000a
➝ 928.8 ÷ 97000 = a
➝ 0.0095 m/s² = a
.........도움......
Is this correct? (the option is marked)
Answer:
sorry I don't understand this language
Which of the following sentences is incorrect about pressure?
i) Pressure depends upon the amount of force applied.
ii) Pressure depends on the area upon which is the force is applied.
iii) Pressure is a vector quantity.
iv) The force acting per unit area is called pressure
Answer:
iii) pressure is a vector quantity.
derive an expression for resistivity of conductor of length l and area of cross section A
Answer
Resistivity R = K * L / A where resistivity is constant for material, L the length of the material and A the area of the material
K = R * A / L where R is the resistance of the material
If the velocity of a motorcycle increases from 30 mis too 50m/s in 10 seconds what will be the acceleration of motorcycle?
Answer:
2 m/s^2
Explanation:
a = ∆v / ∆t
a = (50 - 30) / 10
a = 20 / 10
a = 2 m/s^2
acceleration = u-v/t
50-30/10
=2m/s
Those of you who have recently finished high school physics-did you struggle? If you did, where did you most struggle in? Was it the tests? Or a specific topic?
Thank you!
Answer:
I'm over halfway through it so don't have a complete answer but i think you just need to keep ontop of everything and write down all the key equations on flashcards or something and aim to learn them at the beginning of each topic. i found the longer questions hard so recommend practising those
Explanation:
What unit is used to measure the period of a wave?
A. Seconds
B. Meters
C. Hertz
D. Meters/second
Answer:
D. Meters/Seconds
Explanation:
The time period of a wave is measured in seconds.
A typical wave involves both time and distance. Consider a sound wave, which is basically a periodic modulation of the local air pressure. We "hear" the sound because our ears respond to the variations of pressure.
The most common metric of a sound wave is frequency. This is the rate at which the change in pressure occurs, and is measured in cycles per second, formally known as "hertz". The period is the inverse of frequency andl has the units of seconds per cycle, commonly stated simply as seconds.
How can a simulation study be used to learn about a planet we have never visited?
In a simulation study you imitate some conditions and characteristics of the real planet. The simulation can be used as a substitute for real data collected on the planet.
Simulation studies can be used for planets we have already visited.
In a simulation study you imitate as many conditions and characteristics as possible of the real thing, in this case the planet you have not visited. By simulating as many conditions as possible you can visualize what the planet might be like and learn things about it without actually visiting it.
Simulation studies cannot be used to learn about a planet we have never visited because we do not know anything about the planet.
A simulation study that is used to learn about a planet by simulating as many conditions as possible, you can visualize what the planet might be like and learn things about it without actually visiting it. The correct option is c.
What is simulation?A simulation is a method of simulating a process or change in the actual world to forecast future events or to explain past events and their causes. These days, simulations are frequently carried out using computers. Scientists use simulations to find answers and to test complicated systems.
A fire drill is used in this instance to get everyone ready for an impending event. In fire drills, the fire alarm is sounded even when there isn't actually a fire.
Therefore, the correct option is c.
To learn more about simulation, refer to the link:
https://brainly.com/question/16359096
#SPJ2
Why does temperature increase when heat is lost?
Answer:
Since kinetic energy is one of the forms of internal energy, the release of heat from an object causes a decrease in the average kinetic energy of its particles. This means that the particles move more sluggishly and the temperature of the object decreases.
Explanation:
Joule is equal to:
Awatt x metre
B.watt x second
C. Newton x Metre
D. Both b and c
Answer:
The answer is ( D) i. e both b and c.
which substance is an acid ?
Answer:
According to Arrhenius definition, an acid is a substance that releases hydrogen ion or hydronium ion.
there are also other definition like bronsted and lewis.
I HOPE IT WILL HELP
The plane of a5cm*8cm rectangular loop of wire is parallel to a 0.19T magnetic field the loop carries a current of 6.2 A. What torque acts on aloop? What is the magnetic moment of the loop?
Answer:
Torque; τ = 4.712 × 10^(-3) J
Magnetic moment; M = 0.0248 J/T
Explanation:
Torque is gotten from the formula;
τ = BIA
Where;
B is magnetic field
I is current
A is area
We are given;
B = 0.19T
I = 6.2A
Rectangle dimensions = 5cm by 8cm = 0.05m by 0.08m
Thus;
Area; A = 0.05m × 0.08m = 0.004 m²
Thus;
τ = 0.19 × 6.2 × 0.004
τ = 4.712 × 10^(-3) J
Formula for the magnetic moment is given by;
M = IA
M = 6.2 × 0.004
M = 0.0248 J/T
A motorcycle is moving at a constant velocity of 15 meters/second. Then it starts to accelerate and reaches a velocity of 24 meters/second in 3 seconds. What’s the acceleration of the motorcycle over this time? Use .
A.
9 m/s2
B.
8 m/s2
C.
6 m/s2
D.
5 m/s2
E.
3 m/s2
option E
3m/s square
hope it helped u
Rearrange this equation so it equals d
v=dt
Answer:
Below
Explanation:
To solve for d rearrange the formula v = (d)(t) to:
d = v / t
I'm not to sure if you are using different variables but usually in physics the formula for velocity is v = d / t not v = dt
If you wanted to solve for displacement you would do:
d = (v)(t)
Hope this helps!
Which statement best describes the arrangement of electrons in an atom of fluorine (F)?
(1 point) giving brainliest for sure
There are two electrons in the first energy level and seven electrons in the second energy level.
There are two electrons in the first energy level and five electrons in the second energy level.
There are five electrons in the first energy level and two electrons in the second energy level.
There are seven electrons in the first energy level and two electrons in the second energy level.
Flourine is an element which has 9 electrons. The first energy level can only hold upto 2 electrons so therefore two electrons of the fluorine element will be in the first orbital.
In the second orbital there will be seven electrons. The configuration will be as 1s2, 2s2 , 2p5 .
The first orbital has capacity of two electrons and then the remaining two electrons will be in higher second energy level.
The further 5 electrons will be in lower second energy level which is denoted by p.
Learn more at https://brainly.com/question/24373325
Answer:
#1. 5
#2.They have valence electrons in the same energy level.
#3. Helium atoms have 2 valence electrons, while atoms of the other elements in the group all have 8 valence electrons.
#4. cesium (Cs)
#5. There are two electrons in the first energy level and seven electrons in the second energy level.
Explanation:
in order for the average velocity to be different from the avergae speed, what has to be true of the object's motion?
Answer:
ok
Explanation:
Acceleration is defined as the rate of change of velocity.
Acceleration = (Change in velocity) / time taken
Acceleration = (Final velocity - initial velocity) / time
As the object velocity changes by the same amount in each second, it means the acceleration is constant.
Two difference between thrust and upthrust .
Upthrust is the upward force exerted by fluids on the surface of an object immersed in fluids. Thrust:- It is the force acting perpendicular to the surface. Upthrust:- It is the upward force exerted by the fluid on the surface of an object immersed in liquid.
I hope it's help you
3. Calculate the wavelength of wave that has a frequency of 4.75 x 1012Hz.
a. 1.43 x 1021 m
b. 6.31 x 105 m
1.58 x 104 m
d. 6.31 x 105 m
please help
C.
We know
[tex]\boxed{\sf \lambda=\dfrac{C}{V}}[/tex]
[tex]\\ \sf\longmapsto \lambda=\dfrac{3\times 10^8ms^{-1}}{4.75\times 10^{12}s^{-1}}[/tex]
[tex]\\ \sf\longmapsto \lambda=0.631\times 10^{-4}m[/tex]
[tex]\\ \sf\longmapsto \lambda=6.31\times 10^{-5}m[/tex]
can anyone please help me
Answer:its most likely c
Explanation:
what is field selection process
It is a process of offering jobs to desired candidates and offering jobs to the desired applicant.
Logam P dan Q sejenis. Logam P yang memiliki panjang 1 meter dipanaskan hingga mengalami kenaikan suhu 12ºC, akibatnya logam bertambah panjang 0,2 cm. Logam Q juga dipanaskan hingga mengalami kenaikan suhu 10°C dan panjangnya bertambah 0,1 cm. Tentukanlah panjang mula-mula logam Q!
Answer:
I don't know ???
sorry
Plz Help me thank uuu...
Which of these is a likely impact of the stronger than normal trade winds on the eastern Pacific ocean?
Warm surface water builds up, causing lower than average temperature.
Warm surface water builds up, causing higher than average temperature.
Warm surface water is reduced, causing colder conditions than normal.
Warm surface water is reduced, causing hotter conditions than normal.
Answer:
Jet stream would be displaced southwards causing heavy rain and flooding.
Explanation:
The other options of the question were A) Jet stream would be displaced northwards causing drought. B) Jet stream would be displaced southwards causing drought. D) Jet stream would be displaced northwards causing heavy rain and flooding,
The statement that is a likely impact of stronger than normal trade winds in the Pacific Northwest to the United States is "Jet stream would be displaced southwards causing heavy rain and flooding."
We are talking about climate or weather terminology. In this case, we are referring to the "El Niño" (the Children) effect. Its presence affects the weather in North America. This phenomenon combines with the "La Niña) effect and it presents itself every two to seven years, ad they last from 8 to 12 months, affecting the weather conditions of the region.
Answer:
jet stream should be displaced southwards which causes heavy rainfall and flood.
Describe manipulated Variable
Which of the following would cause the force of kinetic friction to increase?
A. A decrease in the normal force
B. An increase in us
C. A decrease in lk
D. An increase in the normal force
Answer:
Increase in μk
Explanation:
different ans set
A 9V battery produces a 1.5A current in a piece of wire. What is the resistance of the wire?
8 Ω
9 Ω
6 Ω
7 Ω
Explanation:
Using Ohm's Law and a bit of substitution, we can use voltage divided by current to solve for resistance. Doing that, we'll get 6 Ohm.
Electricity flows from
positive to positive
negative to positive
negative to negative
positive to negative
Answer:
is it from positive to negative am I right tell me if I am wrong
Answer:
positive to negative
The flow of electric current is similar to the flow of water which is from higher level to lower level.
The electric current flow from higher potential region(positive* low concentration of electron) to lower potential region(negative*high concentration of electron)
What is the symbol SI unit of time?
Answer:
second is the SI unit of time
Ag,Au and Cu are called coinage metals why plzzzz hurry its urgent plzzz
Answer:
This is because these metals are used for minting (making) coins.
Answer:
It is bcz it is used for making coins
Q- Wheel of a running vehicle has which energy?
(a) Vibrational Kinetic energy
(b) Translational Kinetic energy
(c) Rotational Kinetic energy
(d) All of the above
Answer:
Rotational kinetic energy
Explanation:
It is caused by circular motion.
its important please answer
Answer: Well we see that v= u- ft/m
lets say that ft= feet and m= mass
so you divide those and subtract u
leaving you with the value of v which is 13
How long will it take a 6000W motor to lift a 5000kg load through a height of 2.5m?
Answer:
20.4375 seconds.
Explanation:
Wattage = Work / time
Work = f * d
F = mass * acceleration
mass = 5000 kg
acceleration = force of gravity
acceleration = 9.81
Force = 5000 * 9.81
Force = 49050 N
Work = F * d
d = 2.5
Work = 49050 * 2.5
Work = 122625 Joules
Wattage = Work / time
time = work / wattage
wattage = 6000 watts
time = 122625 / 6000
time = 20.4375 seconds.
