R= 40cm —> R= 0.4 m
P= 2mm —> P= 0.002 m
[tex]V.R = \frac{2πR}{p} = \frac{2 \times 3.14 \times 0.4}{0.002} = 1256[/tex]
I think this is the answer
I hope I helped you
Good luck ^_^
Two difference between thrust and upthrust .
Upthrust is the upward force exerted by fluids on the surface of an object immersed in fluids. Thrust:- It is the force acting perpendicular to the surface. Upthrust:- It is the upward force exerted by the fluid on the surface of an object immersed in liquid.
I hope it's help you
how do you think the weight and the lift should not be one of the same magnitude
because weight disappear and doesn't show the actual weight in the lift
Q- Wheel of a running vehicle has which energy?
(a) Vibrational Kinetic energy
(b) Translational Kinetic energy
(c) Rotational Kinetic energy
(d) All of the above
Answer:
Rotational kinetic energy
Explanation:
It is caused by circular motion.
How long will it take a 6000W motor to lift a 5000kg load through a height of 2.5m?
Answer:
20.4375 seconds.
Explanation:
Wattage = Work / time
Work = f * d
F = mass * acceleration
mass = 5000 kg
acceleration = force of gravity
acceleration = 9.81
Force = 5000 * 9.81
Force = 49050 N
Work = F * d
d = 2.5
Work = 49050 * 2.5
Work = 122625 Joules
Wattage = Work / time
time = work / wattage
wattage = 6000 watts
time = 122625 / 6000
time = 20.4375 seconds.
Electricity flows from
positive to positive
negative to positive
negative to negative
positive to negative
Answer:
is it from positive to negative am I right tell me if I am wrong
Answer:
positive to negative
The flow of electric current is similar to the flow of water which is from higher level to lower level.
The electric current flow from higher potential region(positive* low concentration of electron) to lower potential region(negative*high concentration of electron)
define 1 second time
Answer:
define 1 second time
One second is the time that elapses during 9,192,631,770 (9.192631770 x 10 9 ) cycles of the radiation produced by the transition between two levels of the cesium 133 atom. ... One second is equal to 1/86,400 of a mean solar day.
Answer:
One part of 86400 part of a day is called one second time.
✌✌✌✌
Which of the following would cause the force of kinetic friction to increase?
A. A decrease in the normal force
B. An increase in us
C. A decrease in lk
D. An increase in the normal force
Answer:
Increase in μk
Explanation:
different ans set
can anyone please help me
Answer:its most likely c
Explanation:
How can a simulation study be used to learn about a planet we have never visited?
In a simulation study you imitate some conditions and characteristics of the real planet. The simulation can be used as a substitute for real data collected on the planet.
Simulation studies can be used for planets we have already visited.
In a simulation study you imitate as many conditions and characteristics as possible of the real thing, in this case the planet you have not visited. By simulating as many conditions as possible you can visualize what the planet might be like and learn things about it without actually visiting it.
Simulation studies cannot be used to learn about a planet we have never visited because we do not know anything about the planet.
A simulation study that is used to learn about a planet by simulating as many conditions as possible, you can visualize what the planet might be like and learn things about it without actually visiting it. The correct option is c.
What is simulation?A simulation is a method of simulating a process or change in the actual world to forecast future events or to explain past events and their causes. These days, simulations are frequently carried out using computers. Scientists use simulations to find answers and to test complicated systems.
A fire drill is used in this instance to get everyone ready for an impending event. In fire drills, the fire alarm is sounded even when there isn't actually a fire.
Therefore, the correct option is c.
To learn more about simulation, refer to the link:
https://brainly.com/question/16359096
#SPJ2
Those of you who have recently finished high school physics-did you struggle? If you did, where did you most struggle in? Was it the tests? Or a specific topic?
Thank you!
Answer:
I'm over halfway through it so don't have a complete answer but i think you just need to keep ontop of everything and write down all the key equations on flashcards or something and aim to learn them at the beginning of each topic. i found the longer questions hard so recommend practising those
Explanation:
20. A semiconductor is a
A) crystalline solid that conducts current under any condition
B) metallic solid that conducts current under any condition
C) metallic solid that conducts current under certain conditions
D) crystalline solid that conducts current under certain conditions
Answer:
D) crystalline solid that conducts current under certain conditions
Explanation:
A semiconductor is any crystalline solid material whose electrical conductivity is intermediary between that of insulators and conductors. That is, a semiconductor does not conduct like a conductor but does more than an insulator.
Based on this, a semiconductor is said to only conduct electricity under certain conditions as opposed to conductors that do so under any condition. Example of semiconductors are silicon, carbon, antimony, arsenic etc.
What is the symbol SI unit of time?
Answer:
second is the SI unit of time
If the velocity of a motorcycle increases from 30 mis too 50m/s in 10 seconds what will be the acceleration of motorcycle?
Answer:
2 m/s^2
Explanation:
a = ∆v / ∆t
a = (50 - 30) / 10
a = 20 / 10
a = 2 m/s^2
acceleration = u-v/t
50-30/10
=2m/s
Which of the following sentences is incorrect about pressure?
i) Pressure depends upon the amount of force applied.
ii) Pressure depends on the area upon which is the force is applied.
iii) Pressure is a vector quantity.
iv) The force acting per unit area is called pressure
Answer:
iii) pressure is a vector quantity.
What unit is used to measure the period of a wave?
A. Seconds
B. Meters
C. Hertz
D. Meters/second
Answer:
D. Meters/Seconds
Explanation:
The time period of a wave is measured in seconds.
A typical wave involves both time and distance. Consider a sound wave, which is basically a periodic modulation of the local air pressure. We "hear" the sound because our ears respond to the variations of pressure.
The most common metric of a sound wave is frequency. This is the rate at which the change in pressure occurs, and is measured in cycles per second, formally known as "hertz". The period is the inverse of frequency andl has the units of seconds per cycle, commonly stated simply as seconds.
Logam P dan Q sejenis. Logam P yang memiliki panjang 1 meter dipanaskan hingga mengalami kenaikan suhu 12ºC, akibatnya logam bertambah panjang 0,2 cm. Logam Q juga dipanaskan hingga mengalami kenaikan suhu 10°C dan panjangnya bertambah 0,1 cm. Tentukanlah panjang mula-mula logam Q!
Answer:
I don't know ???
sorry
Joule is equal to:
Awatt x metre
B.watt x second
C. Newton x Metre
D. Both b and c
Answer:
The answer is ( D) i. e both b and c.
The plane of a5cm*8cm rectangular loop of wire is parallel to a 0.19T magnetic field the loop carries a current of 6.2 A. What torque acts on aloop? What is the magnetic moment of the loop?
Answer:
Torque; τ = 4.712 × 10^(-3) J
Magnetic moment; M = 0.0248 J/T
Explanation:
Torque is gotten from the formula;
τ = BIA
Where;
B is magnetic field
I is current
A is area
We are given;
B = 0.19T
I = 6.2A
Rectangle dimensions = 5cm by 8cm = 0.05m by 0.08m
Thus;
Area; A = 0.05m × 0.08m = 0.004 m²
Thus;
τ = 0.19 × 6.2 × 0.004
τ = 4.712 × 10^(-3) J
Formula for the magnetic moment is given by;
M = IA
M = 6.2 × 0.004
M = 0.0248 J/T
Rearrange this equation so it equals d
v=dt
Answer:
Below
Explanation:
To solve for d rearrange the formula v = (d)(t) to:
d = v / t
I'm not to sure if you are using different variables but usually in physics the formula for velocity is v = d / t not v = dt
If you wanted to solve for displacement you would do:
d = (v)(t)
Hope this helps!
Why does temperature increase when heat is lost?
Answer:
Since kinetic energy is one of the forms of internal energy, the release of heat from an object causes a decrease in the average kinetic energy of its particles. This means that the particles move more sluggishly and the temperature of the object decreases.
Explanation:
Ag,Au and Cu are called coinage metals why plzzzz hurry its urgent plzzz
Answer:
This is because these metals are used for minting (making) coins.
Answer:
It is bcz it is used for making coins
If the final velocity is 0. third equation of motion will be
Answer:
vf²=vi²+2a∆x
Explanation:
The third equation of motion gives the final velocity of an object under uniform acceleration given the distance traveled and an initial velocity: v 2 = v 0 2 + 2 a d . v^2=v_0^2+2ad. v2=v02+2ad. The graph of the motion of the object.
A 9V battery produces a 1.5A current in a piece of wire. What is the resistance of the wire?
8 Ω
9 Ω
6 Ω
7 Ω
Explanation:
Using Ohm's Law and a bit of substitution, we can use voltage divided by current to solve for resistance. Doing that, we'll get 6 Ohm.
what is field selection process
It is a process of offering jobs to desired candidates and offering jobs to the desired applicant.
which substance is an acid ?
Answer:
According to Arrhenius definition, an acid is a substance that releases hydrogen ion or hydronium ion.
there are also other definition like bronsted and lewis.
I HOPE IT WILL HELP
Which statement best describes the arrangement of electrons in an atom of fluorine (F)?
(1 point) giving brainliest for sure
There are two electrons in the first energy level and seven electrons in the second energy level.
There are two electrons in the first energy level and five electrons in the second energy level.
There are five electrons in the first energy level and two electrons in the second energy level.
There are seven electrons in the first energy level and two electrons in the second energy level.
Flourine is an element which has 9 electrons. The first energy level can only hold upto 2 electrons so therefore two electrons of the fluorine element will be in the first orbital.
In the second orbital there will be seven electrons. The configuration will be as 1s2, 2s2 , 2p5 .
The first orbital has capacity of two electrons and then the remaining two electrons will be in higher second energy level.
The further 5 electrons will be in lower second energy level which is denoted by p.
Learn more at https://brainly.com/question/24373325
Answer:
#1. 5
#2.They have valence electrons in the same energy level.
#3. Helium atoms have 2 valence electrons, while atoms of the other elements in the group all have 8 valence electrons.
#4. cesium (Cs)
#5. There are two electrons in the first energy level and seven electrons in the second energy level.
Explanation:
3. Calculate the wavelength of wave that has a frequency of 4.75 x 1012Hz.
a. 1.43 x 1021 m
b. 6.31 x 105 m
1.58 x 104 m
d. 6.31 x 105 m
please help
C.
We know
[tex]\boxed{\sf \lambda=\dfrac{C}{V}}[/tex]
[tex]\\ \sf\longmapsto \lambda=\dfrac{3\times 10^8ms^{-1}}{4.75\times 10^{12}s^{-1}}[/tex]
[tex]\\ \sf\longmapsto \lambda=0.631\times 10^{-4}m[/tex]
[tex]\\ \sf\longmapsto \lambda=6.31\times 10^{-5}m[/tex]
its important please answer
Answer: Well we see that v= u- ft/m
lets say that ft= feet and m= mass
so you divide those and subtract u
leaving you with the value of v which is 13
Describe manipulated Variable
A motorcycle is moving at a constant velocity of 15 meters/second. Then it starts to accelerate and reaches a velocity of 24 meters/second in 3 seconds. What’s the acceleration of the motorcycle over this time? Use .
A.
9 m/s2
B.
8 m/s2
C.
6 m/s2
D.
5 m/s2
E.
3 m/s2
option E
3m/s square
hope it helped u
