A rectangular loop of wire that can rotate about an axis through its center is placed between the poles of a magnet in a magnetic field with a strength of 0.40 T. The length of the loop L is 0.16 m and its width w is 0.040 m. What is the magnetic flux through the loop when the plane of the loop is perpendicular to the magnetic field?

Answer:

A physic term

Explanation:

Answer:

Cambio de lugar o de posición de un cuerpo en el espacio.

Explanation:

Answer:

In mathematics, the difference of two squares is a squared (multiplied by itself) number subtracted from another squared number. Every difference of squares may be factored according to the identity. in elementary algebra.

Explanation:

Answer:

T1 = T2 = 602.33 N

Explanation:

I attached an image of the forces diagram below.

The x component of the forces for this cases is:

[tex]\Sigma F_x=T_1cos\theta-T_2cos\theta=0\\\\T_1cos\theta=T_2cos\theta\\\\T_1=T_2[/tex]

And the y components:

[tex]\Sigma F_y=T_1sin\theta+T_2sin\theta-W=0\\\\T_1=T_2=T\\\\\Sigma F_y=2Tsin\theta=W\\\\T=\frac{W}{2sin\theta}[/tex]

The angle is calculated by using the information about the length of the cable and the vertical distance of the traffic light:

[tex]\theta=tan^{-1}(\frac{1}{15})=3.81\°[/tex]

Thus, you obtain:

[tex]T=\frac{80N}{2(sin3.81\°)}=601.33N[/tex]

hence, the tension in both segments of the cable is 602.33 N

Answer:

A

Explanation:

maximum gravitional potential energy is at point R

Answer:

electrostatic attraction

Explanation:

Atoms form chemical bonds with other atoms when there's an electrostatic attraction between them. This attraction results from the properties and characteristics of the atoms' outermost electrons, which are known as valence electrons.

Answer:

1/ decreases

2/ yes;

In general there is no relationship, and any combinations of frequencies and amplitudes are allowed.

Explanation:

Explanation for 1/ - please see the picture attached below

Answer:

T = 2.82 seconds.

The frequency [tex]\mathbf{f = 0.36 \ Hz}[/tex]

Amplitude A = 25.5 cm

The maximum speed of the glider is [tex]\mathbf{v = 56.87 \ rad/s}[/tex]

Explanation:

Given that:

the time taken for 11 oscillations is 31 seconds ;

SO, the time taken for one oscillation is :

[tex]T = \frac{31}{11}[/tex]

T = 2.82 seconds.

The formula for calculating frequency can be expressed as :

[tex]f = \frac{1}{T}[/tex]

[tex]f = \frac{1}{2.82}[/tex]

[tex]\mathbf{f = 0.36 \ Hz}[/tex]

The amplitude is determined by using the formula:

[tex]A = \frac{d}{2}[/tex]

The limits that the spring makes the oscillations are from 10 cm to 61 cm.

The distance of the glider is, d = (61 - 10 )cm = 51 cm

Replacing 51 for d in the above equation

[tex]A = \frac{51}{2}[/tex]

A = 25.5 cm

The maximum speed of the glider is:

[tex]v = A \omega[/tex]

where ;

[tex]\omega = \frac{2 \pi}{T}[/tex]

[tex]\omega = \frac{2 \pi}{2.82}[/tex]

[tex]\omega = 2.23 \ rad/s[/tex]

[tex]v = A \omega[/tex]

[tex]v = 25.5 *2.23[/tex]

[tex]\mathbf{v = 56.87 \ rad/s}[/tex]

Answer:

The answer is the atom with 3 protons, 4 neutrons, and 3 electrons.

Explanation:

The reason why, is because protons are positive, neutrons are neutral, and electrons are negative. The protons cancel out the electrons, and the neutrons are just there.

Answer:

friction

...............

Answer:

Friction

Explanation:

Friction, air resistance, and tension are other examples of contact forces. Straight from the book. Please give branliest

Answer:

B) Distance and Time

Explanation:

Equation for speed: S = D / T

Speed equals the distance you traveled divided by the amount of time it took to get to that destination.

The two factors which are required to determine the speed of a object are distance traveled by it and time taken by it.

The speed is the rate at which the total distance by a object is traveled in the time taken.

Speed of a object can be given as,

[tex]s=\dfrac{d}{t}[/tex]

Here, (d) is the distance traveled by the object and (t) is time taken but the object to cover that distance.

As the unit of the distance is measured in the meter and the time measure in the second. Thus the speed of a object is measured in the meter per second.

In the vehicles the speed of vehicle is also measured in the kilometre per hour or miles per hour.

Hence, the two factors which are required to determine the speed of a object are distance traveled by it and time taken by it.

Thus the option B is the correct option.

Learn more about the speed here;

https://brainly.com/question/359790

Answer:

0.05 cents per fl oz

Explanation:

0.95 divided by 20

0.0475 to the nearest cent 0.05

Answer:

dont know

Explanation:

need points

Answer:

Pmax = 67.5 KN

Explanation:

We need to calculate the maximum allowable value of P for both aluminum and steel bars.

FOR STEEL BARS:

Since,

(σallow)st = (Pmax)st/A

where,

(σallow)st = maximum allowable stress of steel bar = 200 MPa = 2 x 10⁸ Pa

A = Cross-sectional area of steel bar = 450 mm² = 0.45 x 10⁻³ m²

(Pmax)st = Maximum allowable force for steel bar = ?

Therefore,

2 x 10⁸ Pa = (Pmax)st/0.45 x 10⁻³ m²

(Pmax)st = (2 x 10⁸ Pa)(0.45 x 10⁻³ m²)

(Pmax)st = 9 x 10⁴ N = 90 KN

FOR Aluminum BARS:

Since,

(σallow)al = (Pmax)al/A

where,

(σallow)al = maximum allowable stress of Al bar = 150 MPa = 1.5 x 10⁸ Pa

A = Cross-sectional area of Aluminum bar = 450 mm² = 0.45 x 10⁻³ m²

(Pmax)al = Maximum allowable force for Aluminum bar = ?

Therefore,

1.5 x 10⁸ Pa = (Pmax)al/0.45 x 10⁻³ m²

(Pmax)al = (1.5 x 10⁸ Pa)(0.45 x 10⁻³ m²)

(Pmax)al = 6.75 x 10⁴ N = 67.5 KN

Since,

(Pmax)al < (Pmax)st

Therefore,

The maximum allowable force will be:

Pmax = (Pmax)al

Pmax = 67.5 KN

Answer:

a

Explanation:

Answer:

its a because its the only thing not moving

Explanation:

Answer: tendons connect muscles to bones

Explanation:

Answer:

|v2| = 3.27

Explanation:

You have two vector v1 and v2. The relation between the magnitudes of both vectors is given by:

[tex]\frac{|v_1|}{|v_2|}=\frac{5}{2}[/tex]

Furthermore, the projection (the dot product) of one vector on the other one is given by the following formula:

[tex]v_1 \cdot v_2 = |v_1||v_2|cos\theta[/tex]

The dot product between v1 and v2 is 3√29. If you multiply the right hand side of the last equation by |v2|/|v2| you obtain:

[tex]3\sqrt{29}=\frac{|v_1|}{|v_2|}|v_2|^2cos(53\°)[/tex]

you do |v2| the subject of the formula:

[tex]|v_2|=\sqrt{\frac{|v_2|}{|v_1|}\frac{3\sqrt{29}}{cos53\°}}\\\\|v_2|=\sqrt{\frac{2}{5}\frac{3\sqrt{29}}{cos53\°}}=3.27[/tex]

Answer:

neither

Explanation:

they both suck :)

Have a great day

Answer:

Both of them

Explanation:

They are both better you can't choose because its like parents choosing who is their favorite child.

Answer:

4800

Explanation:

The change in velocity of the car is 17-13=4m/s. Since the change in momentum is the mass multiplied by the change in velocity, the answer is 4*1200=4800. Hope this helps!

Given:

Mass,

Change in velocity,

            =  4 m/s

Now,

The change in momentum is:

= [tex]Mass\times Change \ in \ velocity[/tex]

= [tex]1200\times 4[/tex]

= [tex]4800[/tex]

Thus the above answer is correct.

Learn more about momentum here:

https://brainly.com/question/8644950

Answer:

Matter in the universe is made up of atoms, particles if electrons were to be stationary, they would have fallen into the nucleus because of electrostatic force acting on them destroying very existence of an atom we know.

Answer:

I think it might be A: Alec but tell me if I'm wrong

Explanation:

Answer:

a

Explanation:

i did it on e d g e n u i t y

Answer: The period will be larger, with T = 4.92 seconds

Explanation:

The period of a pendulum can be obtained by the equation

T = 2*pi*√(L/g)

Where pi = 3.14, L = lenght of the pendulum and g = gravity acceleration.

You can see that the gravitational acceleration is on the denominator, this means that if we decrease the value of g, then the value of T will increase.

In Earth we have that:

2s = 2*3.14*√(L/9.8m/s^2)

L = (1/3.14)^2*9.8 m = 1m

In the moon we have g = 1.62 m/s^2

then the period in the moon is:

T = 2*3.14√(1/1.62) = 4.92s

Answer:

Nuclear fusion is the process in which two atomic nuclei are fused together into a larger single nucleus, releasing energy in the process. ... In proton-proton fusion, four hydrogen atoms are fused into a single helium-4 atom, releasing a lot of energy in the process.

Explanation:

Answer:

b

Explanation:

Answer:

b

Explanation:

trust

Answer:

Electrons

Explanation:

Ionised atoms loose and gain electrons.

hope it helps!

Answer:

0.45 miles

Explanation:

since, car will be running on the edge of track, distance covered in one lap by car will be equal to circumference of track.\

we will use value of pi as 22/7

Circumference for any circular shape is given by [tex]\piD[/tex][tex]\pi D[/tex]

Hence, in one lap [tex]\pi D[/tex] distance will be covered

in 7 laps [tex]7 \pi D[/tex] distance will be covered.

but is given that 7 laps should be equal to 10 miles

so 10 miles will be equal to [tex]7\pi D[/tex]

[tex]7\pi D= 10 \ miles\\=> 7*(22/7)* D= 10 \ miles\\=> 22D = 10 \ miles\\=> D = 10/22 \ miles\\=> D = 0.45 \ miles[/tex]

Thus, diameter of track will be 0.45 miles to meet the requirement.

Answer:

c

Explanation:

not sure i think heating beach

Answer:

The strong force binds quarks together in clusters to make more-familiar subatomic particles, such as protons and neutrons. It also holds together the atomic nucleus and underlies interactions between all particles containing quarks

Explanation:

PLEASE GIVE ME BRAINLIEST IF NEW IT SHOULD SAY MARK AS BRAINLIEST IF NOT YOULL HAVE TO WAIT A DAY AND BRAINLY WILL REMIND YOU