5. According to the law of reflection, the
is equal to the angle of incidence and a line drawn perpendicular to the reflecting surface.
O reflected ray
angle of reflection
O angle of refraction

Answer:

Explanation:

The negative only matters reallly if you are dealing with a 2d system. I could even define down as positive and up as negative. However, usually you are taught that down is negative. It really doesn't matter because a force is a force. It is only given a direction relative to another force or vector direction.

Answer:

A1

Explanation:

Answer:

the positive and negative terminals of a battery are connected with a low resistance conductor.

Answer:

a ) Its wavelength decreases

Explanation:

When a ray enters into air from glass slab its wavelength decreases.

Answer:

1. These lines are addressed to Duke.

2. These lines show that Shylock is not willing to forgive the debt a merchant owes him, nor is he willing to justify why he demands that debt be paid, even if it seems cruel.

3. He swore by the Holy Sabbath, which is a holy day for him, who is a Jew. He swore he would get the debt money or a piece of the debtor's flesh.

Explanation:

The lines shown in the question above refer to "The Merchant of Venice" written by Shakespeare. In this story we are introduced to Antonio, a commercial who is very prejudiced against Jews, but when he needs money, he borrows from another merchant, Shylock, who is Jewish. Shylock agrees to lend money to Antonio, but determines the date that this money must be returned, in addition, Shylock states that he will lend the money if Antonio agrees that if this money is not paid by the specified date, Antonio will have to pay with half a kilo of flesh from his own body. Antonio agrees, but doesn't pay the money so Shylock goes after the flesh of Antonio's body and Duke tries to intervene because he thinks this is too cruel. At this point, Shylock speaks the lines shown in the question above, showing that he is not willing to change his mind.

Answer:

D is the answer wave behavior

Interference, refraction, diffraction, and dispersion are all aspects of wave behavior. (D).  That is, particles don't do these things.

Answer:

B

Explanation:

Stress-strain diagram with 4 materials graphed. The graph with maximum yield strength is B.

Stress is defined as the force applied per unit area of cross-section. It is denoted by Sigma(σ). Its's unit is same as the pressure i.e. N/m².

Considering the stress-strain diagram shown here. Assumed all four material samples denoted as (A-D) were originally the same size and shape.

When a body is stretched by a tensile force, it stretches more and more until it reaches its elastic limit. There comes a point where the body no longer stretches. The change in stress is very less and the stress is greater at the yield point. The strength required up to the yield point is called as the yield strength. The body breaks while forming the neck of the bottle. This strength of any material is known as ultimate stress at break or ultimate tensile strength.

So, the material with the highest yield strength is B.

Thus, the correct option is B.

Learn more about Stress.

https://brainly.com/question/12871096

#SPJ5

Answer:

a) the other components are zero, in the direction of one of the coordinate axes

b) the magnitude is less than the value of one of its components, it must occur when the vector is in some arbitrary direction

9) constant velocity the acceleration must necessarily be zero,

constant speed  can be accelerated since it may be changing the direction of the velocity vector

Explanation:

Vectors are quantities that have modulo (scalar) direction and sense.

a)  If in a vector its magnitude is equal to one d its components implies that the other components are zero, therefore the vector must be in the direction of one of the coordinate axes

b) if the magnitude is less than the value of one of its components, it must occur when the vector is in some arbitrary direction, other than the direction of the axes, that is

          R² = x² + y²

where R is the magnitude of the vector e x, and are the components

9) When a particle has a constant velocity, the acceleration must necessarily be zero,

         v = vo + a t

The bold letters indicate vectors If a = 0 implies that v = vo

If a particle has constant speed it can be accelerated since it may be changing the direction of the velocity vector, this type of acceleration has the name of centripetal acceleration

Answer:

La ecuación para la velodiad del sonido en aire esta dada por:

[tex]v = \sqrt{ \frac{\gamma*R*T}{M} }[/tex]

Resolviendo esto para T, obtenemos:

[tex]T = v^2*(\frac{M}{\gamma*R} )[/tex]

donde:

T = temperatura del aire en grados Kelvin

γ = constante adiabatica = 1.4

R = constante del gas ideal =

M = masa molar del aire = 29*10^(-3) kg/mol

Si sabemos que el primer día la velocidad es 346 m/s, tenemos:

v = 346 m/s

Ahora podemos reemplazar todos esos valores en la ecuación para T, y asi obtener:

[tex]T = (346m/s)^2*(\frac{29*10^{-3}kg/mol}{1.4* 8.31 J/mol*K} ) = 298.42 K[/tex]

Para el segundo día la velocidad es 340 m/s, entonces ese día la temperatura va a ser:

[tex]T = (340m/s)^2*(\frac{29*10^{-3}kg/mol}{1.4* 8.31 J/mol*K} ) = 288.16 K[/tex]

12 × sin50 = 9.192533317........

Answer:

Hydrogen ion concentration, [H+] :

[tex]{ \bf{[H {}^{ + } ] = 2.3 \times {10}^{ - 5} \: mol \: l {}^{ - 1} }}[/tex]

Substitute to the negative logarithmic model:

[tex] = { \tt{ - log(2.3 \times {10}^{ - 5} ) }} \\ pH = 4.64[/tex]

Answer:

increase

Explanation:

guesshejwoowsnnsnakalalapqjhdjd

Answer:

our weight would decrease.

Explanation:

because of you burning all those calories and fat from hiking up the mountain.

Answer:

7.8 N

Explanation:

Applying,

I = Ft................. Eqaution 1

Where I = Impulse on the egg test dummy, F = Force on the egg test dummy during the time interval, t = time interval

make F the subject of the equation

F = I/t.................. Equation 2

From the question,

Given: T = -0.39 N.s, t = 0.050 s

Substitute these vales into equation 2

F = -0.39/0.050

F = -7.8 N

Hence the force that act on the egg test dummy is 7.8 N

Answer:

Cannot be determined from the given information

Explanation:

Given the following data;

Velocity = 24 m/s

Period = 3 seconds

To find the amplitude of the wave;

Mathematically, the amplitude of a wave is given by the formula;

x = Asin(ωt + ϕ)

Where;

x is displacement of the wave measured in meters.

A is the amplitude.

ω is the angular frequency measured in rad/s.

t is the time period measured in seconds.

ϕ is the phase angle.

Hence, the information provided in this exercise isn't sufficient to find the amplitude of the waveform.

However, the given parameters can be used to calculate the frequency and wavelength of the wave.

Answer:

Explanation:

W = FΔx so filling in:

12 = F(30) so

F = .4N

Answer:

hey !! here is a short and sweet answer to your question

=quality of life is directly determined by health ,education ,and life expectacy

=health Is a type of thing that gives employment to the person working in firm

hope u understand

Explanation:

Answer:

If 2 objects have the same mass, then which object has a larger volume will have a smaller density

Explanation:

Because density is the object's mass divided by volume

Answer:

(C) 2 kHz

Explanation:

The normal hearing frequency range of a person has a minimum of about 20 Hz, which is the about the frequency of the lowest pipe organ pipe. The maximum frequency that a human can ear comfortably is 20 kHz

Therefore, the student will not be able to hear sounds less than 20 Hz, and sounds above 20 kHz and the student will only be able to hear the 2 kHz sound.

Answer:

2) zero acceleration

Explanation:

Motion can be defined as a change in the location (position) of a physical object or body with respect to a reference point.

This ultimately implies that, motion would occur as a result of a change in location (position) of an object with respect to a reference point or frame of reference i.e where it was standing before the effect of an external force.

Mathematically, the motion of an object is described in terms of time, distance, speed, velocity, position, displacement, acceleration, etc.

In physics, acceleration can be defined as the rate of change of the velocity of an object with respect to time.

Generally, an object is said to be in equilibrium when neither the energy possessed by the object not state of motion changes with respect to time. Thus, the vector sum of all the forces acting upon an object that's in equilibrium is zero.

In conclusion, an essential characteristic of an object in equilibrium is zero (0) acceleration because there's no change in its velocity with respect to time.

Answer: The use of S I Unit brings uniformity in measurements.

Explanation:

The S I unit is the international system of units which are used to express the magnitudes or quantities of important natural phenomena. It is used universally as a standard for measurements thereby creating an avenue for uniformity in measurements. The base units that makes up the SI unit are:

--> Length: this is measured in meters (m)

--> Time: this is measured in seconds (s)

--> Mass: this is measured in kilogram (kg)

--> Temperature: this is measured in Kelvin (k)

--> Electric current: this is measured in ampere (A).

--> Amount of substance: this is measured in mole

--> Luminous intensity: this is measured in candela (cd)

These units are used as the standard to make our judgement of measurement more reliable and accurate. And since there is only one basic unit for each quantity (example length which is measured in meters) there is no need for further conversions.

Answer:

vhijko and eye rudiieidjdjddjjd

Explanation:

jdjdjdjdjfjofkd ruudoeksowkosksd and nkdeondjvndkxnfuvjfk

Group of answer choices.

A. Energy is absorbed in the reaction.

B. Energy is released in the reaction.

C. There is no transfer of energy in the reaction.

D. Energy is lost in the reaction.

Answer:

B. Energy is released in the reaction.

Explanation:

A chemical reaction can be defined as a chemical process which typically involves the transformation or rearrangement of the atomic, ionic or molecular structure of an element through the breakdown and formation of chemical bonds to produce a new compound or substance.

Basically, there are two (2) main types of chemical reaction and these include;

I. Endothermic reaction: it's a chemical reaction in which heat is absorbed

II. Exothermic reaction: it's a chemical reaction in which heat is liberated into the environment.

In Chemistry, all chemical equation must follow or be in accordance with the Law of Conservation of Mass, which states that mass can neither be created nor destroyed by either a physical transformation or a chemical reaction but transformed from one form to another in an isolated (closed) system.

Generally, energy is released in a chemical reaction when the energy of the products is less than the energy of the reactants and it is referred to as an exothermic reaction.

However, when the energy of the products is greater than the energy of the reactants, energy is absorbed and it is referred to as an endothermic reaction.

Answer:

155mEq/L Cl-

Explanation:

A Ringer’s solution contains the following concentrations of cations: 146 mEq/L of Na+, 5 mEq/L of K+, and 4 mEq/L of Ca2+.

As Cl- is the only counterion of those cations:

For Na, the molecule is NaCl and the mEq/L of Cl- = mEq of Na+. The Cl- of the first ion is 146mEq/L Cl-

For K+, The molecule is KCl, mEq Cl- = 5mEq/L Cl-

And, for Ca2+, The molecule is CaCl2 but the equivalents of Ca2+ = Equivalents of Cl- = 4mEq/L Cl-

The total concentration of Cl- are:

146 + 5 + 4 =

Answer:

A. So that you can see if the answer to a problem makes physical sense.

Explanation:

Science can be defined as a branch of intellectual and practical study which systematically observe a body of fact in relation to the structure and behavior of non-living and living organisms (animals, plants and humans) in the natural world through experiments.

An experiment can be defined as an investigation which typically involves the process of manipulating an independent variable (the cause) in order to be able to determine or measure the dependent variable (the effect).

This ultimately implies that, an experiment can be used by scientists to show or demonstrate how a condition causes or gives rise to another i.e cause and effect, influence, behavior, etc in a sample.

Measurements refers to the process which typically involves the process of identifying and determining the dimensions of a physical object. The dimensions include important parameters such as width, height, length, area, volume, circumference etc.

In Science, making rough estimates of physical quantities is useful so that you can see if the answer to a problem makes physical sense.

For example, you could make a rough estimate of a storage tank and deductively determine whether or not it's in tandem with its physical size in reality.

Answer:

physical measurement comprises the measurement of objects, things, etc. and is concerned with the measurement of height, weight, length, size, volume etc.

Explanation:

The change in momentum from an force within the system.