You lift a 44 N box from the floor and place it on a shelf that is 1.5 m above the ground . How much work did you use in lifting the box ?

Answer:

it begins to move to the right! :)

Answer:

Por que existe una relación entre dichas magnitudes.

Para un pendulo perfecto de largo L, sabemos que el periodo esta definido como:

[tex]T = 2*\pi *\sqrt{L/g}[/tex]

Donde:

pi = 3.14

L = largo del péndulo

g = aceleración gravitatoria = 9.8 m/s^2

Entonces podemos ver que el periodo es proporcional a la raíz cuadrada de la longitud del péndulo.

Esto es por lo que al analizar datos de un experimento se debería observar una relación entre esas magnitudes.

Answer:

Consider an isolated system of 2 bodies A & B. An isolated system means where there is no external force acting.Now let F be the force acting on B by A & F be the force acting on A by B.Now rate of change of momentum of A =dpA/dt and rate of change of momentum of B =d pB/dt

thus FAB=d pB/dt (i)......

FBA=dpA/dt (ii)........

Adding 1 and 2 we get FAB+FBA=d pB/dt+dpA/dt =d(pB+pA)/dt

But if no force is applied momentum will also be 0 because no velocity will be there so rate of change of momentum will also be 0

thus d(pA+pB)/dt=0

therefore FAB+FBA=0

or,FAB=-FBA

(3RD LAW OF MOTION)

Answer:

0.3 cm

Explanation:

[tex] \frac{2.4}{8} \\ = 0.3[/tex]

Answer:

the answer is 4m/ s²

hope this helps love!! <3

Answer:

his displacement is 772.85 ft

Explanation:

Given;

initial velocity of his jump, u = 2 ft/s

final velocity of his jump, v = - 223 ft/s

time of motion, t = 7 seconds

acceleration due to gravity, g = 32.17 ft/s²

Let downward motion = positive direction

Let his displacement after 7s = Δh

Apply the following kinematic equation to determine his displacement.

[tex]v^2 = u^2 + 2g\Delta h\\\\(-223)^2 = (2)^2 + (2\times 32.17)\Delta h\\\\49,729 = 4 + 64.34\Delta h\\\\-64.34 \Delta h = 4 - 49,729\\\\-64.34 \Delta h = -49,725\\\\\Delta h = \frac{49,725}{64.34} \\\\\Delta h = 772.85 \ ft[/tex]

Therefore, his displacement is 772.85 ft

Answer:

So every hour he makes 10 miles.  So he would take 1 and a half hours to go to Mcdonalds 15 miles away.

Explanation:

[tex]\huge\boxed{{\textsf{90 minutes}}}[/tex]

We know that Mike's speed is [tex]\dfrac{10\ \text{miles}}{60\ \text{minutes}}[/tex] since there are [tex]60[/tex] minutes in an hour, and we know that MIke needs to travel [tex]15[/tex] miles. We'll model this using fractions:

[tex]\dfrac{10\ \text{miles}}{60\ \text{minutes}}=\dfrac{15\ \text{miles}}{x\ \text{minutes}}[/tex]

We can see that there is a [tex]2:3[/tex] ratio here, so we'll divide the left fraction by [tex]2[/tex] and multiply it by [tex]3[/tex] to get the right fraction.

[tex]\dfrac{10}{60}\Rightarrow\dfrac{5}{30}\Rightarrow\dfrac{15\ \text{miles}}{\boxed{90\ \text{minutes}}}[/tex]

Answer:

C

Explanation:

Seat belts absorb kinetic energy when a car crashes because it pulls you back from falling forward given the kinetic energy (and momentum) you had before the crash.

Air bags absorb kinetic energy when a car crashes because it pushes you back from falling forward given the kinetic energy (and momentum) you had before the crash.

Crumple zones absorb kinetic energy when a car crashes because it provides a cushion when the cars crash. Kind of like dropping your phone into a pillow.

I hope this helps! :)

Answer:

C. Seat belts, crumple zones and air bags

Explanation:

All of these car safety features absorb kinetic energy, including seat belts, crumple zones and air bags.

Answer:

there it is fella

we neglect the mass data

Work is equal to the magnitude of the force multiplied by the displacement x. Assuming Magali is pushing the phone, so that the force and displacement point in the same direction, then the work done is positive, and

2.7 J = (4.5 N) x   ==>   x = (2.7 J) / (4.5 N) = 0.60 m

Even if she was pulling the phone instead, the displacement would be the same, but the work done would be negative and the force would point in the opposite direction, thus also having a negative sign:

-2.7 J = (-4.5 N) x   ==>  x = 0.60 m

Answer:

I have a screenshot of this.

Explanation:

Answer:

I think true

Explanation:

I hope I'm right and I hope it helps

Answer:

true

Explanation:

basta yun yung sagot ko

Answer:

more acidic (less base)

hope this helps! :)

Answer:

The number of beats is 10.58 in 35°C.

Explanation:

The beat frequency is given by : f₁-f₂

At 5°C, f₁-f₂ = 4

We need to find the number of beats in 35°C​.

The frequency in a standing wave is proportional to [tex]\sqrt T[/tex].

So,

[tex]\dfrac{f_1-f_2}{f_1'-f_2'}=\dfrac{\sqrt {T}}{\sqrt{T'}}\\\\f_1'-f_2'=(f_1-f_2)\times \dfrac{\sqrt{T'}}{\sqrt{T}}\\\\f_1'-f_2'=4\times \dfrac{\sqrt{35}}{\sqrt{5}}\\\\f_1'-f_2'=10.58[/tex]

So, the number of beats is 10.58 in 35°C.

Answer:

[tex]n _{v} = \frac{c}{v} \\ = \frac{3 \times {10}^{8} }{2.30 \times {10}^{8} } \\ = 1.30[/tex]

This question involves the concept of refractive index.

The refractive index of the vinegar is "1.3".

The refractive index is defined as the ratio of the speed of light in air and the speed of light in the given medium which is vinegar here.

[tex]\eta = \frac{c}{v}[/tex]

where,

Therefore,

[tex]\eta = \frac{3\ x\ 10^8\ m/s}{2.3\ x \10^8\ m/s}[/tex]

η = 1.3

Learn more about refractive index here:

https://brainly.com/question/23750645

#SPJ2

Answer:

Hope this is what you were looking for!

Explanation:

1) So, if we are talking about balancing a straight stick (beam), he could put a finger from each hand on either side of it and move them together. As a result of friction his fingers will meet at the balance point.

2) Method of trial and error.

Answer:

2.4 secs.

Explanation:

Current (A) = Charge (coulomb)/Time(sec)

We are looking for time. So:

Time (sec) = Charge (coulomb)/Current (A)

↓

12coulombs/5.0A = 2.4 secs

Answer:

a) A = 3 cm,  b)  T = 0.4 s,   f = 2.5 Hz,

2) A standing wave the displacement of the wave is canceled and only one oscillation remains

Explanation:

a) in an oscillatory movement the amplitude is the highest value of the signal in this case

          A = 3 cm

b) the period of oscillation is the time it takes for the wave to repeat itself in this case

          T = 0.4 s

the period is the inverse of the frequency

         f = 1 /T

         f = 1 /, 0.4

         f = 2.5 Hz

2) a traveling wave is a wave for which as time increases the displacement increases, in the case of a transverse wave the oscillation is perpendicular to the displacement and in the case of a longitudinal wave the oscillation is in the same direction of the displacement.

A standing wave occurs when a traveling wave bounces off some object and there are two waves, one that travels in one direction and the other that travels in the opposite direction. In this case, the displacement of the wave is canceled and only one oscillation remains.

Answer:

i) densidad

ii) conductividad eléctrica

Explanation:

Las propiedades características de una sustancia se denominan también propiedades intrínsecas. Estas son propiedades que no dependen de la cantidad de sustancia presente.

Las propiedades características se pueden utilizar para identificar una sustancia porque son propiedades que siempre debe exhibir la sustancia.

Entre las opciones, podemos encontrar las siguientes sustancias características;

i) densidad

ii) conductividad eléctrica

Explanation:

the PE = Weight x g x Height above ground where g is the gravitational constant (9.8m/s^2)

so tge PE = 100 x 9.8 x 25 = 24500 J

Answer:

A Permanent magnet or a static magnet

Explanation:

A permanent magnet is an object made from a material that is magnetized and creates its own persistent magnetic field. Materials that can be magnetized, which are also the ones that are strongly attracted to a magnet, are called ferromagnetic (or ferrimagnetic).

Answer:

The relationship between voltage, current, and resistance is described by Ohm's law. This equation, i = v/r, tells us that the current, i, flowing through a circuit is directly proportional to the voltage, v, and inversely proportional to the resistance, r.

Answer:

Sirius

Explanation:

On the HR diagram Sirius is the closet.

c) Sirius has a surface temperature and luminosity closest to Phecda

Surface temperature is the temperature at or near a surface. Luminosity is an absolute measure of radiated electromagnetic power (light), the radiant power emitted by a light-emitting object over time.

As it can be observed from the graph attached that Sirius have a surface temperature of about 10,000 K which can be considered as closest to 9500 K comparatively to other stars and if we see the the y coordinate of Sirius which is the luminosity representing axis , then Sirius have a value of luminosity closer to 63

hence correct answer is c)Sirius

learn more about surface temperature  and luminosity :

https://brainly.com/question/15099713?referrer=searchResults

#SPJ2

Answer:

ans: 6 m/s

Explanation:

spaceship 1 has mass= 150kg

initial momentum of spaceship 1 = 900 kg•m/s

we know,

momentum = mass × velocity

so,

velocity = momentum/mass

= 900 / 150

= 6 m/s

since we know it was initial momentum so, velocity is initial speed,

Answer:

Gravitational force becomes sixteen times lesser. The strength of the gravitational force between two objects is dependent on their mass. Gravitational force will be weaker if the objects move further away from each other.

This was used to solve for the gravitational force,

G = gravitational constant

m = mass of the first object

M = mass of the second object

d = distance between the two objects

[G * (m*M) / 16d^2] = 1/16

Answer:

diffraction phenomenon

Explanation:

When you place your finger in front of a flash, you have a diffraction phenomenon whereby the light fills a part of the space with the first maximum diffraction.

In this case the phenomenon of geometric optics cannot explain the process of bending the beam around an object.

Answer:

It is True that Humans are not the only animals that pollute the air.

True

Every animal exhales CO2, that's why they pollute the air too, except that it is much less than that of humans.