22)When iron rusts in air, iron(III) oxide is produced. How many moles of oxygen will react
with 2.4 mol of iron ?
4Fe(s) + 3O2(g) → 2Fe2O3(s)
A)1.2 mol
B)1.8 mol
C)2.4 mol
D)3.2 mol
E)4.8 mol
show work
Answer:
B
Explanation:
)When iron rusts in air, iron(III) oxide is produced. How many moles of oxygen will react
with 2.4 mol of iron ?
B)1.8 mol
Which of these is true about a pH meter?
It is inexpensive to use.
It measures pH indirectly.
It does not require calibration.
It can be used in any acid-base titration.
Answer:
That is, a pH meter is useful in detecting or knowing the acidity (due to ions) or alkalinity (due to ions) of a solution. Thus, we can conclude that out of the given options it is true about a pH meter that it can be used in any acid-base titration
Answer: D. It can be used in any acid-base titration.
Explanation:
Which two laws were discovered by Antoine Lavoisier and Joseph Proust?
Does a reaction involving an acid and a base have to take place in a water environment? Justify your answer.
Answer:
YES!!!
Explanation:
Strong acids and strong bases are both strong electrolytes. In contrast, only a fraction of the molecules of weak acids and weak bases react with water to produce ions, so weak acids and weak bases are also weak electrolytes.
How much heat is required to raise the temperature of 16.0 grams H2O from 5.000C to 75.00C? Below is a list of constants.
specific heat for H2O(s) = 2.1 J/g0C
specific heat for H2O(L) = 4.18 J/g0C
specific heat for H2O(g) = 1.7 J/g0C
\bigtriangleup H△Hvap = 40.7 kJ/mol
\bigtriangleup H△Hfus = 6.01 kJ/mol
5.34 J
260 J
4680 J
2350 J
Answer:
The amount of heat required is 4681.6 J.
Explanation:
mass, m = 16 g = 0.016 kg
initial temperature, T = 5 C
final temperature, T' = 75 C
specific heat, c = 4.18 J/g C
The amount of heat required is
H = m c (T'- T)
H = 16 x 4.18 x (75 - 5)
H = 4681.6 J
what is the slope of the line segment
-3
-1/3
1/3
3
Answer:
slope = 3
Explanation:
[tex]slope = \frac{3 - 0}{1 - 0} \\ = 3[/tex]
Briefly explain why adding insulation to an attic helps reduce heating costs.
Answer:
Insulation reduces the exchange of heat through a surface such as a wall, attic, duct or roof. In a well-insulated home, less warm air escapes from the house during the winter, and less cool air escapes during the summer, reducing the amount of energy needed for heating and cooling
WHAT HAPPENS WHEN ELECTRIC CURRENT PASSES THROUGH ACIDIFIED WATER.
Answer:
When an electric current is passed through acidified water, it decomposes to give hydrogen and oxygen gas. The hydrogen gas is obtained at the cathode and the oxygen gas is obtained at the anode
How are liquid water, ice, water different from each other?
Answer: In liquid water, water molecules are moving faster. They are still close together, but they are no longer stuck in a rigid pattern as they are in ice. Water molecules in liquid water are constantly sliding past and bumping into each other; they keep moving from one place to another.
Answer:
they are different forms
Explanation:
ice is solid
and water is liquid
they also have different densities
Chemistry 1 question please help!! 10 points
Answer:
3
Explanation:
its the 3 one it is
Witch two chemists organized the elements based on properties suck as how the elements reacts or whether they are solid or liquid
Answer:
Antoine Lavoisier and Johann Wolfang Döbereiner organized the elements based on properties such as how the elements reacts or whether they are solid or liquid.
Explanation:
The periodic table of the elements as we have it today was developed as a result of the work of several notable centuries who lived centuries apart, all of who made notable contributions to development of the modern periodic table in use today.
In 1789, Antoine Lavoisier, a French Chemist provided a definition of elemets which he defined as a substance whose smallest units cannot be broken down into a simpler substance. He further grouped the elements into two as metals and nonmetals.
In 1829, German physicist Johann Wolfang Döbereiner arranged elements in groups of three in increasing order of atomic weight and called them triads. His arrangement owasf elements into triads was based on his observation of similarities in physical and chemical properties of certain elements.
John Newlands, a British Chemist was the first to arrange the elements into a periodic table with increasing order of atomic masses.
In 1869, Russian chemist Dmitri Mendeleev developed a periodic table which provided a framework the modern periodic table. He arranged the elements according to their atomic weight, leaving gaps for elements that were yet to be discovered.
The modern periodic table arranges elements based on increasing atomic number.
A ball falls 5 m and then bounces to a height of 3 m. What height is the best
reference point for the motion of the ball?
A. 2 m
B. Om
C. 5 m
D. 3 m
SUBMIT
The metric system is also known as the
Answer:
THE answer is all of above
Explanation:
What plate forms a boundary with the African plate
Answer:
The Eurasian plate(another major plate), the Aegean sea plate and the Anatolian plate share the north border. The Antarctic plate that contributes to the south of the African plate, is also a major plate.
show using dots to illustrate high population density and low population density in the boxes provided in answer to guide questions
Answer:
Just add a plenty of dots in the first one and very few dots in the second one
An area with high population density will have many dots while areas will low population density will have few dots when using dots to illustrate population density.
What is population density?Population density is the ratio of the total number of organisms found in a given area to the total of the area of that place or habitat.
Population density = total number of organisms/total areaAn area with high population density indicates that more organised ate found per unit area than an area with low population density.
Therefore, using dots to illustrate population density, an area with high population density will have plenty dots while areas will low population density will have few dots scattered over.
Learn more about population density at: https://brainly.com/question/13902749
Elias read a book about California earthquakes. He then wrote a three-
paragraph report about the book. Which of the following active reading
strategies did Elias use?
A. Making mental images
B. Drawing inferences
C. Summarizing
D. Making predictions
What is Geothermal Energy?
Answer:
Geothermal energy is basically the thermal energy generated and stored in the Earth. It is the energy that determines the temperature of matter.
Explanation:
I hope this helped :)
Answer:
Geothermal energy is heat that's inside of the ground. It is a renewable energy source because heat is constantly being produced inside of the earth.
Explanation: Hope this helps! :)
an atom of an element is represented as 39/19x, write its
(1) number of protons
(2)number of neutrons
(3)Electric configuration
(4)number of valence electrons
Answer:
Solution :
Lithium
Z = 3
P = 3
E = 3 = (2, 1) p=3
A = 7 n=4
P + n = A
3 + n = 7
N = 4

Carbon
Z = 6
P = 6
E = 6 = (2, 4) p=6
A = 12 n=6
P + n = A
6 + n = 12
N = 6
Use the equation below to answer the following question
2NaHCO3(aq) + Ca(H2PO4)2 (aq) → Na2HPO4 (aq) + CaHPO4 (aq) + 2002 (8) + 2H20 (0)
The theoretical yield of CHPO, is 10 g. If 8 g of CaHPO4 are produced from the reaction shown above, what is the percent yield of CHPO ?
Answer:
Percent Yield = 80%
Explanation:
Percent yield of a reaction is defined as one hundred times the ratio between the actual yield and the theoretical yield. That is:
Percent yield = Actual Yield / Theoretical Yield * 100
Where theoretical yield of CaHPO4 is 10g and actual yield is 8g
Replacing:
Percent yield = 8g / 10g * 100
Percent Yield = 80%how does evelyn hear music?
Which of the following could possibly be true about a strong acid? (Check all that apply:).
It will completely dissociate (break apart) when dissolved in water.
It could have a pH of 6
It could have a pH of 13
Only a few of the acid molecules will dissociate (break apart).
It could have a pH of 2.
It could have a pH of 9
Answer:
it could have a pH of 2 it will completely dissociate when dissolved in watercalculate the molecular weight of CaCO3.
Answer:
Explanation:
CaCO3 = 1*Ca + 1*C + 3*O
=1*40 + 1*12 + 3*16
=40 + 12 + 48
=100 amu
You will not measure the enthalpy of the reaction of ______ in the coffee cup calorimeter because this reaction involves gases. Instead, you will use a well-known published value.
HCI and MgO
HCI and Mg
H2 and O2
Answer:
H2 and O2
Explanation:
A coffee cup calorimeter is basically a type of calorimeter that operates at constant pressure. The heat measured in the calorimeter is equal to the change in enthalpy of the reaction.
This type of calorimeter is apt for reactions involving solutions where there is little or no change in volume.
It is not generally applicable to gas phase reactions such as the reaction between H2 and O2.
Answer:
You will not measure the enthalpy of the reaction of
✔ H2 and O2
in the coffee cup calorimeter because this reaction involves gases. Instead, you will use a well-known published value.
C. H2 and O2
Is Correct
If the pH = 6.5, what is the [H+]? *
3.16 x 10-7
3.16 x 10-6
O
3.16 x 10-5
Answer:
Key Concepts
The hydrogen ion concentration in a solution, [H+], in mol L-1, can be calculated if the pH of the solution is known.
pH is defined as the negative logarithm (to base 10) of the hydrogen ion concentration in mol L-1 pH = -log10[H+] ...
[H+] in mol L-1 can be calculated using the equation (formula): [H+] = 10-pH
More items...
Explanation:
Answer:
[tex]pH = - log[H {}^{ + } ] \\ 6.5 = - log[H {}^{ + } ] \\ [H {}^{ + } ] = {10}^{ - 6.5} \\ [H {}^{ + } ] = 3.16 \times {10}^{ - 7} \: mol {dm}^{ - 3} [/tex]
Which of the following correctly ranks the following bonds in order from most to least polar?
C-H, N-H, O-H, F-H
a)
O-H > F-H > N-H > C-H
b)
F-H > N-H > O-H > C-H
c)
C-H > N-H > O-H > F-H
d)
F-H > O-H > N-H > C-H
Answer:
O-H F-H N-Hy
Explanation:
C-H N-H O-H F-H
A carbon atom that is surrounded by four hydrogen atoms has a _____ molecular geometry. This geometry results from the arrangement of the _____ hybrid orbitals around the carbon atom. They are formed when the s-orbital and ______ -orbitals mix, or hybridize.
Answer:
Tetrahedral, sp3, p
Explanation:
C has 4 bonds and hence its tetrahedral shape with 109.5 degrees. since there are 4 bonds, it is sp3
Answer:
A carbon atom that is surrounded by four hydrogen atoms has a
✔ tetrahedral
molecular geometry.
This geometry results from the arrangement of the
✔ four sp3
hybrid orbitals around the carbon atom.
They are formed when the s-orbital and
✔ three p
-orbitals mix, or hybridize.
Explanation:
Por qué razón se fomenta la inmigración Europea?
Hola aquí va la respuesta!
Se fomentó la inmigración europea porque la economía no era buena y vinieron a Paraguay para mejorar su situación.
Hola aquí va la respuesta!
Se fomentó la inmigración europea porque la economía no era buena y vinieron a Paraguay para mejorar su situación.
Describe the four states of matter.
From lithium and cesium which is less electronegative?
Answer:Electronegativity, symbolized as χ, is the tendency of an atom to attract shared electrons (or electron density) to itself.
Explanation:
Answer:
Explanation:
The correct answer is cesium
Because If you look at the electronegativities of just Lithium and Cesium then you would notice that the shielding effect is more prevalent in Cesium, thereby reducing the electronegativity and affecting the reduction potential
Calculate the total amount of energy required in calories to convert 50.0 g of ice at 0.00 degrees Celsius to steam at 100. degrees Celsius.
Specific heat capacity of water is 1.00 cal/g OC
Hfusion = 80 cal/g OC and Hvap = 540 cal/g OC
Write the complete equation you will use. 1 point
Substitute the values in the equation in step 1. 1 point
Report the math answer with 3 sig figs and the correct unit. 1 point
Answer:
HFusion*mass + Spec.Heat*mass*ΔT + HVap*mass
80cal/g*50.0g + 1.00cal/g°C*50.0g*(100°C-0°C) + 540cal/g*50g
3.60x10⁵cal
Explanation:
Using the HFusion we can find the heat needed to convert the ice to liquid water.
With specific heat capacity we can find the heat needed to increase the temperature of water from 0 to 100°C.
With HVap we can find the heat to convert the liquid water into steam.
The equations are:
HFusion*mass + Spec.Heat*mass*ΔT + HVap*massComputing the values:
80cal/g*50.0g + 1.00cal/g°C*50.0g*(100°C-0°C) + 540cal/g*50g36000cal =
3.60x10⁵cal