Three circuits diagrams are shown. Which statement about the circuit diagram is accurate?

Answer:

Effort = 540 Newton

Explanation:

Given the following data;

Load arm = 60 cm

Effort arm = 40 cm

Load = 360 N

Conversion:

100 cm = 1 meters

40 cm = 40/100 = 0.4 meters

60 cm = 60/100 = 0.6 meters

To calculate the effort that Reha should apply to lift Neha, we would use the expression;

Effort * effort arm = load * load arm

Substituting into the expression, we have;

Effort * 0.4 = 360 * 0.6

Effort * 0.4 = 216

Effort = 216/0.4

Effort = 540 Newton

Answer:

The iron bolt is attracted to the electromagnet. The force of attraction between the electromagnet's core and the iron bolt is greater than the force of the spring, so the iron bolt is pulled out of its housing in the door

Explanation:

Answer:

Refer to the attachment!~

Answer:

if there is only one planet in the universe and the ball is there it will have 0 kinetic energy if the ball is in the very center of that planet only if the planet itself is absolutely motionless. its at its highest if the planet is moving away from the ball at a slightly faster speed forever. Between point A and B both potential energy and kinetic energy are at perfect 0.

Explanation:

never will have a measurable kinetic or potential energy status unless every single object is included in the calculation.

Answer:

Kayla. You can calculate it using the formula for momentum: momentum=mass×velocity and find the bigger number between the two momentums

Answer:

Gravitational force -an attractive force that exists between all objects with mass; an object with mass attracts another object with mass; the magnitude of the force is directly proportional to the masses of the two objects and inversely proportional to the square of the distance between the two objects.

Explanation:

hope it helped

Answer:

<7

Explanation:

This is a reaction between a steong acid and a weak base which produces a acidic salt at equvalence point. Hence pH is less than 7

Answer:

According to Carl Sagan's Baloney Detection Kit notes

"Whenever possible there must be independent confirmation of the facts"

Independent confirmation by other scientist is to ensure that the observation of the over 40% efficient solar panel is repeatable

It is also important to avoid accepting the given mandates at face value and accepting that the scientist considered all factors when taking the results or that the original developers has assigned others to check their findings before the introduction of the new type of solar cell

Explanation:

Answer:

A -500J

Explanation:

because W=Fs

100 × 5 = 500

The work done by friction is 500 J.

Friction is the force resisting the relative motion of solid surfaces, fluid layers, and material elements sliding against each other.There are several types of friction:

Dry friction is a force that opposes the relative lateral motion of two solid surfaces in contact. Dry friction is subdivided into static friction ("stiction") between non-moving surfaces, and kinetic friction between moving surfaces. With the exception of atomic or molecular friction, dry friction generally arises from the interaction of surface features, known as asperities

Fluid friction describes the friction between layers of a viscous fluid that are moving relative to each other.

Lubricated friction is a case of fluid friction where a lubricant fluid separates two solid surfaces.Skin friction is a component of drag, the force resisting the motion of a fluid across the surface of a body.

Internal friction is the force resisting motion between the elements making up a solid material while it undergoes deformation.

When surfaces in contact move relative to each other, the friction between the two surfaces converts kinetic energy into thermal energy (that is, it converts work to heat).

Learn more about friction

https://brainly.com/question/1424758

#SPJ2

Answer:

F = 156.3 N

Explanation:

Let's start with the top block, apply Newton's second law

         F - fr = 0

         F = fr

         fr = 52.1 N

Now we can work  with the bottom block

In this case we have two friction forces, one between the two blocks and the other between the block and the surface. In the exercise, indicate that the two friction coefficients are equal

we apply Newton's second law

Y axis

        N - W₁ -W₂ = 0

        N = W₁ + W₂

as the two blocks are identical

        N = 2W

X axis

        F - fr₁ - fr₂ = 0

        F = fr₁ + fr₂

indicates that the lower block is moving below block 1, therefore the upper friction force is

          fr₁ = 52.1 N

          fr₁ = μ N

a

s the normal in the lower block of twice the friction force is

          fr₂ = μ 2N

          fr₂ = 2 μ N

          fr₂ = 2 fr₁

we substitute

          F = fr₁ + 2 fr₁

          F = 3 fr₁

          F = 3  52.1

          F = 156.3 N

Answer:

Explanation:

The gravitational force equation is

[tex]F_g=\frac{Gm_1m_2}{r^2}[/tex] where G is the gravitational constant. Filling in with what we are given and what we know to be true:

[tex]F_g=\frac{6.67*10^{-11}(59)(59)}{(2.0)^2}[/tex] which, when you do the math, comes out to be

[tex]F_g=5.8*10^{-8}N[/tex], choice A.

Answer:

D

Explanation:

A material that has a high resistivity and prevents charges from moving freely... it is part of insulators...

Plastic is a  material that has a high resistivity and prevents charges from moving freely. Option D is correct.

Plastic is described as a material that comprises an organic compound with a significant molecular weight as an important element.

Insulators are often defined as materials that do not allow electricity to flow through them.

Insulators are also referred to as poor electrical conductors. Insulators include materials such as paper, glass, rubber, and plastic.

Plastic is a  material that has a high resistivity and prevents charges from moving freely.

Hence option D is correct.

To learn more about the plastic refer to the link;

https://brainly.com/question/23509463

Answer:

the work done by the woman is 6,000 J

Explanation:

Given;

force applied by the woman, F = 400 N

distance moved by the woman, d = 15 m

The work done by the woman is calculated as follows;

W = F x d

W = 400 N x 15 m

W = 6000 Nm = 6,000 J

Therefore, the work done by the woman is 6,000 J

Answer:

Energy is: the ability to do work

The formula for energy is: power x time = energy

Explanation:

Hope this helps (there isn't really an explanation)

Explanation:

Two uses of convex mirror are: (i) It is used as a rear view mirror in vehicles. (ii) It is used as a vigilance mirror. (iii) it is used as a reflector in street lamps.

Explanation:

Inside buildings. You might have noticed that large office buildings, stores, hospitals, and other many other buildings have convex mirrors in the corners. ...

Sunglasses. We might have used sunglasses many times. ...

Vehicle mirrors. ...

Magnifying glasses. ...

For security purposes. ...

Street light reflectors.

Answer:

Las limitaciones de un modelo o prototipo son;

1) Los parámetros ambientales (donde se opera el modelo, prototipo o producto) son diferentes y, por lo tanto, pueden producir relaciones y factores ambientales que serán diferentes de los factores ambientales y las relaciones del objeto real.

2) El análisis del problema puede ser inadecuado

3) La posibilidad de falta de satisfacción del cliente con un modelo, preferencia por la demostración real del producto.

4) Reproducción inexacta del entorno del producto durante la prueba del modelo

5) El factor de costo del modelo

6) Mayor complejidad introducida por el modelo / prototipo al análisis de la solución

Explanation:

El modelo o prototipo es la presentación del diseño articulado, construido para demostrar el producto real con el propósito de encontrar la existencia de errores en el diseño que serían corregidos, antes de que se realice la producción real

Answer:

(D)

Explanation:

When switch C is opened then, Current is not flowing across 3 So bulb 3 will go out.

But current is flowing across 1 and 2 bulb because their switch is closed

therefore bulb 1 and 2 will remain it.

Hence, option (D) will be correct.

yes their density are equal

Because of the position on the equator, the change in rotation of the Earth on its axis throughout the year doesn't affect it much. Unlike the poles, Quito is almost constantly in direct view of the sun. So, because of lack of change in rotation, the daylight hours are hardly varied as Quito is almost constantly in more or less the same spot in relation to the sun.

Explanation:

The voltage of the lamp, V = 240 V

Power of the lamp, P = 40 W

It is running for 62 hours.

The cost of running is $2.50k per KWH

Electric power is,

P = 40×62 Wh

= 2480 Wh

P = 2.48 kWh

At the rate of $2.5 per kWh

P = $6.2

So, the cost of running is $6.2 per kWh.

Answer:

Explanation:

The sensor contains an LDR which has a resistance of 10kohlms in daylight and 100kohlms in the dark.

If the resistor in the circuit is 1 megaohlm, the total resistance in daylight and darkness will be 1.01 megaohms and 1.1 megaohlms.

The percentage difference = (1.1-1.01)/1.1*100% = 8.18%

If the resistor in the circuit is 25 kohlm, the total resistance in daylight and darkness will be 35 kohms and 125 kohlms.

The percentage difference = (125-35)/125*100% = 72%

With the input p.d to the sensing circuit fixed at 12 v, the sensing current will change according to the total resistance. A 72% difference is much more detectable. So the 25 kohm resistor is the better choice.

Answer:

Explanation:

V=IR

I=12/(R of resistor + R of LDR)

R of LDR = 10kohm in light and = 100kohm in dark

R1 =  25kohm

R2 = 1Mohm

solve 4 current

                       light                                       dark

R1        12/(25+10)=0.343mA          12/(25+100)=0.096mA

R2       12/(1000+10)=0.012mA       12/(1000+100)=0.011mA

so R1 is better as its easier 2 tell its light or dark

By Newton's second law, the net force acting on the crate parallel to the surface is

∑ F = mg sin(10°) - 800 N = ma

where m = 500 kg is the mass of the crate and a is the acceleration.

Solve for a :

a = ((500 kg) (9.80 m/s^2) sin(10°) - 800 N) / (500 kg)

a ≈ 0.102 m/s^2

Answer:

[tex]g=16.31\ m/s^2[/tex]

Explanation:

Given that,

The length of the pendulum, l = 2 m

The period of the pendulum, T = 2.2 s

The formula for the time period of a pendulum is given by :

[tex]T=2\pi \sqrt{\dfrac{l}{g}}[/tex]

or

[tex]T^2=4\pi ^2\dfrac{l}{g}\\\\g=\dfrac{4\pi ^2l}{T^2}\\\\g=\dfrac{4\pi ^2\times 2}{(2.2)^2}\\\\g=16.31\ m/s^2[/tex]

So, the free fall acceleration is [tex]16.31\ m/s^2[/tex].

Answer:

ur mom hahahahahhahaahahahahahaha

Explanation:

loserrrrrrrrrrr

Answer:

40 degrees Celsius

Explanation:

Have a great summer :)

Answer:

The correct option is (b).

Explanation:

Given that,

The height of the object, h = 15 cm

Object distance, u = -44 cm

Image distance, v = -14 cm

We need to find the focal length of the lens. Using the lens formula.

[tex]\dfrac{1}{f}=\dfrac{1}{v}-\dfrac{1}{u}\\\\\dfrac{1}{f}=\dfrac{1}{(-14)}-\dfrac{1}{(-44)}\\\\f=-20.53\ cm[/tex]

So, the focal length of the lens (-20.53 cm).