Answer:
Technician A Is right
Explanation:
Reinforcements, as the name suggests, are used to enhance the mechanical properties of a plastic. Finely divided silica, carbon black, talc, mica, and calcium carbonate, as well as short fibres of a variety of materials, can be incorporated as particulate fillers.
PWM input and output signals are often converted to analog voltage signals using low-pass filters. Design and simulate the following: a PWM signal source with 1 kHz base frequency and adjustable pulse-width modulation(PWM source), an analog filter with time constant of 0.01 s. Simulate the input and output of the low pass filter for a PWM duty cycle of 25, 50, and 100%
Answer:
Attached below
Explanation:
PWM signal source has 1 KHz base frequency
Analog filter : with time constant = 0.01 s
low pass transfer function = [tex]\frac{1}{0.01s + 1 }[/tex]
PWM duty cycle is a constant block
Attached below is the design and simulation into Simulink at 25% , 50% and 100% respectively
A river has an average rate of water flow of 59.6 M3/s. This river has three tributaries, tributary A, B and C, which account for 36%, 47% and 17% of water flow respectively. How much water is discharged in 30 minutes from tributary B?
Answer:
50421.6 m³
Explanation:
The river has an average rate of water flow of 59.6 m³/s.
Tributary B accounts for 47% of the rate of water flow. Therefore the rate of water flow through tributary B is:
Flow rate of water through tributary B = 47% of 59.6 m³/s = 0.47 * 59.6 m³/s = 28.012 m³/s
The volume of water that has been discharged through tributary B = Flow rate of water through tributary B * time taken
time = 30 minutes = 30 minutes * 60 seconds / minute = 1800 seconds
The volume of water that has been discharged through tributary B in 30 seconds = 28.012 m³/s * 1800 seconds = 50421.6 m³
