6.022 × 10^23 ×2 = 12.044 × 10^ 23 atoms
Answer:
In one mole of water, there will exist approximately 6.02⋅1023 water molecules. So, there will be a total of 6.02⋅1023⋅2≈1.2⋅1024 hydrogen atoms.
under which conditions do you expect helium gas to deviate most from ideal behavior?
Answer:
Explanation:
[2-0] NC Special Operation
[2] Supervisor
[2-1] Emergency Response
[2-2] Juggernaut
[2-3] Commander
[2-4] Division Director
what is the coefficient for 4K2CO3
How do erosions affect land forms?
Erosion is the only cause of land form changes.
Land forms can be created by erosion.
Erosion can prevent land forms from being built.
Land forms can only be created through erosions.
Answer:
the anwser is landforms can be created by erosion
Explanation:
When a gas is collected over water, the partial pressure of water must be subtracted from the total pressure. If the total pressure was 761 mmHg and the pressure for water is 17.2 torr, what is the pressure due to the gas collected
Answer is: the partial pressure of the hydrogen 500 mmHg.
p(total) = 523.8 mmHg.
p(water) = 23.8 mmHg.
p(total) = m(water) + p(hydrogen).
p(hydrogen) = p(total) - p(water)..
p(hydrogen) = 523.8 mmHg - 23.8 mmHg.
p(hydrogen) = 500 mmHg.
mmHg or millimeter of mercury is a manometric unit of pressure.
What is the role of cellular respiration in organisms?
to provide energy for photosynthesis
to provide energy for breaking apart fuel molecules
to provide energy for making oxygen
to provide energy for cell activity
Answer:
C. sorry if I'm wrong ...................
How does a phase change from solid to liquid occur in a substance?
A. Heat energy is released from the substance, weakening the electrical attraction between molecules.
B. Heat energy is released from the substance, strengthening the electrical attraction between molecules.
C. Heat energy is added to the substance, weakening the electrical attraction between molecules.
D. Heat energy is added to the substance, strengthening the electrical attraction between molecules.
Answer:
see below
Explanation:
1. Heat energy is added to the substance, weakening the electrical attraction between molecules.
2. Both the melting point and boiling point are lower.
3. dipole
4. Water and ethanol have different molecular structures.
5. The lone pairs of electrons in the oxygen atom causes the molecule to be bent; the oxygen atom has a partial negative charge, while the hydrogen atoms have partial positive charges.
[quizlet: captncrun]
Heat is a form factor that changes the solid from light to light to gaseous mediums. The phases take place in a cyclic manner.
The solid to liquid changes take place due to the melting or fusion, solid to gas take lace through the sublimation, liquid to gas is by vaporization, and gas to liquid is condensation. Thus the heat is added and leads to the weakening of the electrical attraction within the molecules.Hence the correct option is C.
Learn more about the phase change from solid to liquid occur in a substance
brainly.com/question/25664350.
Please help I have a C in advance chemistry
Answer:
I think it's 2.50M IM NOT SURE THOUGH SO I RECOMMEND WAITING FOR ANOTHER ANSWER
What is infrared energy? simplify it
Answer:
It is a type of radiant energy that's invisible to human eyes but that we can feel as heat.
7. What is the name of the compound AICO3?
Answer:
Calcium carbonate
Explanation:
Hope this helps :)
Have an amazing day <3
Which of the following shows a valid combustion reaction?
2Al + 2O2 → 2AlO + O2
C2H4 + 3O2 → 2CO2 + 2H2O
2CH4 + O2 → 2CO + 4H2
Ca + O2 → CaOH
Answer: C2H4 + 3O2 → 2CO2 + 2H2O
Explanation:
2Al + 2O2 → 2AlO + O2 Not Balanced Properly: 2Al + O2 = 2AlO
C2H4 + 3O2 → 2CO2 + 2H2O Looks Good
2CH4 + O2 → 2CO + 4H2 Not Correct: CO should be CO2
Ca + O2 → CaOH Not Balanced and No source for the H
Answer:
2H4+3O2 →2CO2+2H2
Explanation:
Choose the statement that is TRUE. Question 26 options: Outer electrons efficiently shield one another from nuclear charge. All of the answers are true Valence electrons are most difficult of all electrons to remove. Core electrons effectively shield outer electrons from nuclear charge. Core electrons are the easiest of all electrons to remove.
The statement which is true is Core electrons effectively shield outer
electrons from nuclear charge.
Core electrons are those which are in close proximity with the nucleus. The
core electrons repel the outer electrons farther away from the nucleus to
shield it from nuclear charge.
The valence electrons are usually found in the outermost part of the shell
and they are the easiest to remove due to the fact that they have to achieve
a stable octet configuration which makes them easily removed during
chemical reactions.
Read more on https://brainly.com/question/371590
Answer: core electrons effectively shield outer electrons from nuclear charge
Explanation:
what type of intermolecular force causes the dissolution of nacl in water?
Answer:
ion-dipole forces
Explanation:
positive sodium ion will be attracted to the slightly negative oxygen atoms in the water molecule, while the negative chloride ion is attracted to the slightly positive hydrogen atoms.
when calculating specific heat what if the change in temperature is negative?
Answer:
If AT and q are negative, then heat flows from an object into its surroundings. If a substance gains thermal energy, its temperature increases, its final temperature is higher than its initial temperature, then AT>0 and q is positive.
What is the frequency of light with a wavelength of 450 nm?
Answer:
The frequency of blue light that has a wavelength of 450 nm is 6.7×1014 6.7 × 10 14 Hz.
Explanation:
BRAINLIEST?
A copper sulphate solution contained 0.100 moles of copper sulphate dissolved in 0.500 dm cubed of water. Calculate the mass of copper sulphate in 30.0cm cubed of this solution. Relative formula mass (mr): CuSO4= 159.5
Answer:
cm^3 —> dm^3
divide by 1000
159.5 — Mr of CuSO4
n (moles in mol) = c (concentration in mol/dm^3) * v (volume in dm^3)
0.100 mol of CuSO4 dissolved in 0.5dm^3 of water
calculate for mass of CuSO4 dissolved in 0.03dm^3 (30cm^3) of the solution
n = m/Mr
m = n*Mr
if 0.1 mol is dissolved in 0.5 dm^3 of water
0.5/0.03 ≈ 16.66666667
0.1 = 0.05
0.1 / 16.66666667 = 0.006
0.5 / 16.66666667 = 0.03
0.006 (mol of CuSO4) = 0.03 (dm^3 solution)
0.006 * 159.5 = 0.957 g
I think this is the answer
The mass copper sulphate CuSO₄ in 30ml solution is 957.6g.
How to determine the mass of copper sulphate in the given solution?To determine the mass of copper sulphate in the given solution, compare both the molarity given
M₁V₁=M₂V₂
n₁/V1=n₂/V2
0.1/0.5=n₂/30 cm³=ml
n₂=6 moles
6×159.5=957.6g
Multiply the calculated moles with the relative mass/molecular mass to get the mass of CuSO₄.
hence, the mass of CuSO₄ is 957.6g
Learn more about dilution equation.
https://brainly.com/question/11493179
#SPJ2
Chemical properties of water and oxygen for class 8
Rank the following molecules (1st, 2nd, 3rd, 4th) in the order that they melt.
Sucrose
Iodine
Sodium
Paraffin
There is a picture attached
Sodium chloride has the highest melting point while iodine has the least melting point.
The melting points of solid substances depends on the nature of intermolecular forces that exists in the substance. The stronger the magnitude of intermolecular forces in a substance, the higher its melting point.
The order of melting points of the solids shown in question is as follows;
1st - Sodium chloride2nd - sucrose3rd - paraffin4th - IodineSodium chloride has the highest melting points because it is an ionic substance. Among the molecular sucrose and paraffin, sucrose has a higher melting point than sucrose because it has a greater molar mass. Iodine, a molecular substance has the least molar mass and the least melting point in the list.
Learn more: https://brainly.com/question/25777663
help me please the subject is siecnce
Answer:
okay your question in science
What will be the product or products if zinc (Zn) reacts with hydrochloric acid (HCl)?.
The products of the reaction are Zinc chloride (ZnCl₂) and Hydrogen gas (H₂)
From the question,
We are to determine the product or products when zinc (Zn) reacts with hydrochloric acid (HCl)
To determine the product or products, we will write the chemical equation for the reaction.
The balanced chemical equation for the reaction is
Zn + 2HCl → ZnCl₂ + H₂
Hence, the products of the reaction are Zinc chloride (ZnCl₂) and Hydrogen gas (H₂)
Learn more here: https://brainly.com/question/17716543
What are the major reservoirs for sulfur
Answer:
the ocean, the ocean floor basalts, evaporite deposits and reduced marine sediments.
Explanation:
Please help. A 208 g sample of sodium-24 decays. How much of this radioactive isotope will remain after 3 half
lifes?
Answer: The information about sequential order of the event occurred in the past can be obtained by using only relative dating method.
Explanation:
Relative dating method doesn’t give information about when it happened. It provides sequential order of the events. It is the art of deciding the overall happening of past occasions (i.e., the age of an item in contrast with another), without fundamentally deciding their outright age (for example evaluated age).
In topography, shake or shallow stores, fossils and lithologies can be utilized to correspond one stratigraphic segment with another.
A fusion reaction always creates which of the following?
a A massive amount of energy.
b A massive amount of heat.
C A more massive atomic nucleus.
d A massive number of smaller nuclei.
A fusion reaction can be regarded as the type of reaction that occurs where two lighter elements come together in a type of reaction giving rise to a heavier/more massive element.
A fusion reaction always creates a more massive atomic nucleus (option c).
When the two lighter nuclei comes together in a reaction, a more heavier/massive nucleus is formed but its mass will still be less than the combined mass of the two reactant nuclei.
This also indicates that the left over mass may have been released as energy.
Learn more: https://brainly.com/question/18175586
A 2.37 g sample of a substance suspected of being pure gold is warmed to 71.8 ∘C and submerged into 15.9 g of water initially at 24.3 ∘C. The final temperature of the mixture is 27.0 ∘C.
Answer:
specific heat capacity of the unknown is 629.66 J/kg C
Explanation:
As we know that gold is heated to 72.3 degree C and mixed with water at 24.8 degree C
Now the final temperature of the mixture is 26 degree C
here we can say that heat given by the gold = heat absorbed by the water
So we will have
Q_{in} = Q_{out}Q
in
=Q
out
2.62 s (72.3 - 24.8) = 15.6 (4186) (26 - 24.8)2.62s(72.3−24.8)=15.6(4186)(26−24.8)
so we will have
s = 629.66 J/kg Cs=629.66J/kgC
so specific heat capacity of the unknown is 629.66 J/kg C
Most elements are ____________. The _____________ elements on the left of the stair-step line on the ______________ of Elements are metals or metal-like _____________. Some of the physical properties of metals are ______________ (shininess) and ___________ density. They are also good conductors of ___________ and ______________. Metals can be hammered into __________sheets.
Answer:
metals, 88 , periodic table , luster , heat, electricity , thin, right, opposite , appearance , luster , malleable , ductile, opposite , shiny, moderately
Explanation:
metals, 88 , periodic table , luster , heat, electricity , thin, right, opposite , appearance , luster , malleable , ductile, opposite , shiny, moderately Is the answer.
(Hope this helps can I pls have brainlist (crown)☺️)
An atom of sodium has 11 electrons. Make a sketch of a sodium atom, showing how many electrons it has at each energy level. Infer how reactive sodium atoms are.
SOMEONE HELP ME PLEASE :(. I DONT GET IT :(
A bar of copper (Copper = 0.385 J/g.°C) and a bar of aluminum (Aluminum = 0.897 J/g.°C) have the same mass. Which requires more energy to increase the temperature from 20°C to 30 °C?
Answer:
Aluminum
Explanation:
how well did the landmases fit together this time
Answer:
The theory of continental drift is most associated with the scientist Alfred Wegener. In the early 20th century, Wegener published a paper explaining his theory that the continental landmasses were “drifting” across the Earth, sometimes plowing through oceans and into each other. He called this movement continental drift.
Explanation:
Which sample is a pure substance?zinc oxidesugar dissolved in waterpond watersoil.
Answer:
Oxide sugar dissolved in water pond
because water + sugar= sugar melts but the oxide purifys the water.
Explanation:
#carryonlearning!
what is the name of the high-energy compound that cells use to fuel chemical reactions?
Answer: Adenosine triphosphate, or ATP, is the primary carrier of energy in cells. The water-mediated reaction known as hydrolysis releases energy from the chemical bonds in ATP to fuel cellular processes.
Explanation:
Potential energy depends on
Question 2 options:
Length and color
Position or shape
Density and volume
Speed and velocity
Answer:
Explanation:
Speed and velocity I think
