H3PO4 + KOH yields K3 PO4 + H2O

need help balancing

Answer:

read the story

Explanation:

read it and then you will find the answer

AnswerExplanation:I finsished d

Answer:

17.55L

Explanation:

0.48mol : 11.7

0.72mol :   x

0.48x = 8.424

x = 17.55

Explanation:

A=Sun

B=Earth

C=Neptune.

hope my answer will definitely help you out.

Answer:

EDTA disodium salt | C10H14N2Na2O8

Explanation:

The final temperature of the mixture in the coffee cup calorimeter is; 19.467 °C

According to the law of energy conservation:

As such; the heat transfer in the liquid water is equal to heat gained by the ice

Heat transfer by liquid water is therefore;

However, since 18g of water makes one mole

T2 = 19.467°C

Read more on heat:

https://brainly.com/question/21406849

Answer:

Answer is 2

Explanation:

directly pro

Answer:

(b) matter is lost and energy is released

Explanation:

When atoms are being formed from its constituent components it weighs less this is called mass defect so the answer would be (b) matter is lost and energy is released.

This question is describing the following chemical reaction at equilibrium:

[tex]A\rightleftharpoons B[/tex]

And provides the relative amounts of both A and B at 25 °C and 75 °C, this means the equilibrium expressions and equilibrium constants can be written as:

[tex]K_1=\frac{90\%}{10\%}=9\\\\K_2=\frac{20\%}{80\%} =0.25[/tex]

Thus, by recalling the Van't Hoff's equation, we can write:

[tex]ln(K_2/K_1)=-\frac{\Delta H}{R}(\frac{1}{T_2} -\frac{1}{T_1} )[/tex]

Hence, we solve for the enthalpy change as follows:

[tex]\Delta H=\frac{-R*ln(K_2/K_1)}{(\frac{1}{T_2} -\frac{1}{T_1} ) }[/tex]

Finally, we plug in the numbers to obtain:

[tex]\Delta H=\frac{-8.314\frac{J}{mol*K} *ln(0.25/9)}{[\frac{1}{(75+273.15)K} -\frac{1}{(25+273.15)K} ] } \\\\\\\Delta H=4,785.1\frac{J}{mol}[/tex]

Learn more:

Answer:

Use the formula PV=nRT to get the temperature

To balance a chemical equation you must pay attention that the algebraic equation has the same number of element atoms in reactant and the product.

A chemical equation is a term to refer to the symbolic description of a chemical reaction, that is, the written representation of symbols. For example:

The balance of an equation can be related to the law of conservation of matter, that is, the number of atoms of each element in the reactants is in the result.

Note: This question is incomplete, because the information some information is missing.

Learn more in: https://brainly.com/question/12271256

[tex]pH = -\log[H^{+}] \\\\\implies \log[H^{+}] = -pH\\\\\implies [H^{+}] = 10^{-pH}\\\\\implies [H^{+}] = 10^{-4.83} = 0.000015[/tex]

One of the oxygen atoms in the anion O3− is hypervalent and the formal charge on this oxygen atom is -1.

Ozone is a triatomic molecule. The anion formed from ozone is called the ozonide anion. This anion is also triatomic. The resonance structures of the ozonide anion are shown in the image attached to this answer.

We can see that one of the oxygen atoms in the ozonide ion is hypervalent because it contains ten instead of eight electrons. This hypervalent oxygen atom has a formal charge of -1 while the two other oxygen atoms has a formal charge of zero.

Learn more: https://brainly.com/question/8646601

Answer:

3

Explanation:

Here's the balanced equation;

C2H4 + 3O2 → 2CO2 + 2H2O

C ⇒2                          C ⇒1 x 2 = 2

H ⇒4                          H ⇒2 x 2 = 4

O ⇒3 x 2 = 6             O ⇒ (2 x 2) + (2 x 1) = 6

The coefficient that has been added as the coefficient to O2 is 3.

C2H4 + 3O2 → 2CO2 + 2H2O.

the given equation has 2oxygen atoms on the reactant side and 3 oxygen atoms on the product side

so to make it equal we have to add 3 as coefficient of O2  on the reactant side.

Therefore the correct answer to the equation C2H4 + 3O2 → 2CO2 + 2H2O is 3.

to know more refer to:

https://brainly.com/question/14818214

#SPJ2

Considering the definition of percentage by mass and molality, the molality of Na₃PO₄ in the solution is 0.948 [tex]\frac{moles}{kg}[/tex].

The percentage by mass expresses the concentration and indicates the amount of mass of solute present in 100 grams of solution.

In other words, the percentage by mass of a component of the solution is defined as the ratio of the mass of the solute to the mass of the solution, expressed as a percentage.

The percentage by mass is calculated as the mass of the solute divided by the mass of the solution, the result of which is multiplied by 100 to give a percentage. This is:

[tex]percentage by mass=\frac{mass of solute}{mass of solution}x100[/tex]

Molality is the ratio of the number of moles of any dissolved solute to kilograms of solvent.

The Molality of a solution is determined by the expression:

[tex]molality=\frac{number of moles of solute}{kilograms of solvent}[/tex]

Considering 100 grams as a sample of the solution, then the value of the percentage of concentration given indicates that  13.5 g correspond to Na₃PO₄.

Remember that percent concentration by mass is calculated using the mass of solute and the mass of the solution, which includes both the solute and the solvent. Then:

mass solution= mass solute + mass solvent

100 g= 13.5 g + mass solvent

100 g - 13.5 g= mass solvent

86.5 g= mass solvent

Then, you know:

Then, replacing in the definition of molality:

[tex]molality=\frac{0.082 moles}{0.0865 kg}[/tex]

Solving:

molality= 0.948 [tex]\frac{moles}{kg}[/tex]

Finally, the molality of Na₃PO₄ in the solution is 0.948 [tex]\frac{moles}{kg}[/tex].

Learn more about:

[tex]▪▪▪▪▪▪▪▪▪▪▪▪▪  {\huge\mathfrak{Answer}}▪▪▪▪▪▪▪▪▪▪▪▪▪▪[/tex]

The Correct choice is ~ D

Solute is the substance that dissolves into another substance

The freezing point of the solution is - 0.12 oC.

We know that;

ΔT = K m i

ΔT = Freezing point depression

K = Freezing constant

m = molality

i = Van't Hoff factor

Number of moles of sucrose= 2.23g/342 g/mol = 0.0065 moles

Mass of solvent in Kg = 0.1 Kg

Molality of the solution = 0.0065 moles/ 0.1 Kg = 0.065 m

Now;

ΔT = 1.86 oC/m × 0.065 m × 1

ΔT = 0.12 oC

Freezing point of pure water = 0 oC

Freezing point of solution =  0 oC -  0.12 oC = - 0.12 oC

Learn more: https://brainly.com/question/2292439

This question is providing the exothermic heat of neutralization of acetic acid in units of kilojoules per mollimole (-49,8 kj/mmol) and asks for the same value but in calories per millimole which results -11,902.5 cal/mmol.

In this case, according to the given problem, it turns out necessary to solve a two-factor conversion in order to convert the kilojoules to joules and finally to calories as shown below:

[tex]-49.8\frac{kJ}{mmol}*\frac{1000J}{1kJ}*\frac{1cal}{4.184J}[/tex]

Thus, we cancel out the kJ and J, to obtain the following result, rounded to one decimal place:

[tex]-11,902.5\frac{cal}{mmol}[/tex]

Learn more:

Answer:

1.1 million pounds

Explanation:

Answer:

1.1 million pounds

Explanation:

that's a lot of water above us!!

The amount of the sample remaining at 4pm is 0.0625 g

We'll begin by calculating the number of half-lives that has elapsed

Half-life (t½) = 1 hour

Time (t) = 4 hour

n = t / t½

n = 4 / 1

Number of half-lives (n) = 4

Initial amount (N₀) = 1 g

[tex]N = \frac{N_0}{ {2}^{n}} \\ \\ N = \frac{1}{ {2}^{4}} \\ \\ N = \frac{1}{16} \\ \\ N = 0.0625 \: g[/tex]

Thus, the amount remaining at 4pm is 0.0625 g

Learn more: https://brainly.com/question/25750315

Answer:

Cr

Explanation:

Cr goes from +3 to +6 and when it increases it means is being oxidized.

The element being oxidized in the redox reaction is Cr. Oxidation state helps to determine the amount of oxidation which an atom undergoes. An increase in oxidation state or number signifies oxidation has taken place.

A decrease in oxidation state depicts reduction has taken place. In this

scenario, the element Cr has a change in oxidation state from +3 to +6 which

signifies oxidation took place in the atoms of the element. This is why Cr will

be the right option.

Read more on https://brainly.com/question/25653911

The explanation to the question is stated as follows:

Newton's first law of motion states that: a body will continue in its state of rest or uniform motion unless an external force acts on it. So then, the ball initially possesses potential energy because it was at rest. While the leg of the soccer player possesses kinetic energy because its in motion.

Thus, when the player hits the ball, a force known as push has been applied. This would ensure that the ball compels and moves in the direction of the applied force. Therefore after the interaction, the leg of the player now possesses potential energy, since it would come to rest after hitting the ball. While the ball would start moving, now possessing kinetic energy.

Visit: https://brainly.com/question/12099288

The answer would be 4.

The agencies are:

Department of Agriculture's Forest Service (AFS)

Department of the Interior's Bureau of Land Management (BLM)

Fish and Wildlife Service (FWS)

National Park Service (NPS)

These four agencies cover around 95% of the land and are the only federal agencies.

I learned about these agencies in school.

Answer:

1. A/Thermal Energy

2. B/The particles within the system will have greater motion, and the temperature will increase.

3. C/Attractions occur due to electrostatic forces. When particles move fast enough, these forces can no longer keep particles together.

4. D/ For a phase change from solid to liquid, the bonds do not break completely and particles can still slide past each other.

5. D/ a sample of liquid benzene at 80ºC and a sample of gaseous benzene at 80ºC

Explanation:

I took the Test.

1. Internal energy associated with systems and particles is thermal energy. Thus, option A is correct.

The internal energy has been described as the energy that has been assessed by the molecules and bonds at the STP. Thermal energy has been the energy of particular molecules and the system comprising all the molecules have the summation of the thermal energy.

Thus, internal energy associated with systems and particles is thermal energy. Thus, option A is correct.

2. The addition of energy results in greater motion with an increase in temperature has been representation no phase change. Thus, option B is correct.

The addition of energy to the substance results in the increased motion of the particles. The energy higher than the threshold energy has been responsible for the phase change of the substance.

The addition of energy results in greater motion with an increase in temperature has been representation no phase change. Thus, option B is correct.

3. The movement of the particles under the gravitational attraction is not enough to hold the particles together at a longer distance. Thus, option B is correct.

The attraction has been the force that has been responsible for holding the particles in a molecule. Different attractions have a different levels of stability and strength.

The movement of the particles under the gravitational attraction is not enough to hold the particles together at a longer distance. Thus, option B is correct.

4. The phase change of the molecules has been mediated by overcoming the force of attraction that allows the molecules to move freely. The solid to liquid phase change has been mediated with the breaking of the attraction between the bonds allowing free movement.

Thus, statement 4 is incorrect, and option D is correct.

5. The kinetic energy has been the energy possessed by the moving molecules in the medium. The molecules in liquid and gas have been possessing the same energy at the same temperature, Thus, option D is correct.

For more information about energy and electrostatic interactions, refer to the link:

https://brainly.com/question/6170401

Answer:

c) single bonds, double bonds, carbon atoms and hydrogen atoms

Answer:

It is an unstable form of a chemical element that releases radiation as it breaks down and becomes more stable.

Answer:

Ptotal=P1+P2+… +Pn. + P nExplanation:

its c

Answer:

i can't understand the question