EJEMPLOS DE SOLUCIONES QUÍMICAS EN LA NATURALEZA

Answer:

Approximately 10.5g or 10.4g [tex]SrF_{2}[/tex]

Answer:

the answer is salt because it has a uniform and definite composition

Explanation:

Answer:

Just add a plenty of dots in the first one and very few dots in the second one

An area with high population density will have many dots while areas will low population density will have few dots when using dots to illustrate population density.

Population density is the ratio of the total number of organisms found in a given area to the total of the area of that place or habitat.

An area with high population density indicates that more organised ate found per unit area than an area with low population density.

Therefore, using dots to illustrate population density, an area with high population density will have plenty dots while areas will low population density will have few dots scattered over.

Learn more about population density at: https://brainly.com/question/13902749

Answer:

Geothermal energy is basically the thermal energy generated and stored in the Earth. It is the energy that determines the temperature of matter.

Explanation:

I hope this helped :)

Answer:

Geothermal energy is heat that's inside of the ground. It is a renewable energy source because heat is constantly being produced inside of the earth.

Explanation:  Hope this helps! :)

Answer:

The Eurasian plate(another major plate), the Aegean sea plate and the Anatolian plate share the north border. The Antarctic plate that contributes to the south of the African plate, is also a major plate.

Answer: Electrolysis is passing an electric current through a liquid containing ions so that decomposition reaction takes place.

Electrolysis is passing an electric current through a liquid containing ions so that decomposition reaction takes place.When an electric current is passed through acidified water, it decomposes to give hydrogen and oxygen gas. The hydrogen gas is obtained at the cathode and the oxygen gas is obtained at the anode.

Electrolysis is passing an electric current through a liquid containing ions so that decomposition reaction takes place.When an electric current is passed through acidified water, it decomposes to give hydrogen and oxygen gas. The hydrogen gas is obtained at the cathode and the oxygen gas is obtained at the anode.The reaction for decomposition of water into oxygen and hydrogen is as follows:

Electrolysis is passing an electric current through a liquid containing ions so that decomposition reaction takes place.When an electric current is passed through acidified water, it decomposes to give hydrogen and oxygen gas. The hydrogen gas is obtained at the cathode and the oxygen gas is obtained at the anode.The reaction for decomposition of water into oxygen and hydrogen is as follows:2H2O(l) -------> 2H2(g) + O2(g)

Answer:

B

Explanation:

)When iron rusts in air, iron(III) oxide is produced. How many moles of oxygen will react

with 2.4 mol of iron ?

B)1.8 mol

Answer:

Percent Yield = 80%

Explanation:

Percent yield of a reaction is defined as one hundred times the ratio between the actual yield and the theoretical yield. That is:

Percent yield = Actual Yield / Theoretical Yield * 100

Where theoretical yield of CaHPO4 is 10g and actual yield is 8g

Replacing:

Percent yield = 8g / 10g * 100

Answer:

Enthalpy is the amount of heat released or absorb. The total enthalpy can be found by subtracting the products' enthalpy by the reactants' enthalpy

Answer:

HFusion*mass + Spec.Heat*mass*ΔT + HVap*mass

80cal/g*50.0g + 1.00cal/g°C*50.0g*(100°C-0°C) + 540cal/g*50g

3.60x10⁵cal

Explanation:

Using the HFusion we can find the heat needed to convert the ice to liquid water.

With specific heat capacity we can find the heat needed to increase the temperature of water from 0 to 100°C.

With HVap we can find the heat to convert the liquid water into steam.

The equations are:

Computing the values:

36000cal =

Answer:

1100L.

Explanation:

Answer:

C

[tex] \triangle \: H {}^{ \theta} _{s} = lattice \: energy + hydration \: energy \\ = + 2526 + ( - 2003 + (2 \times - 340)) \\ + 2526 - 2683 \\ = - 157 \: kjmol {}^{ - 1} [/tex]

Answer:

YES!!!

Explanation:

Strong acids and strong bases are both strong electrolytes. In contrast, only a fraction of the molecules of weak acids and weak bases react with water to produce ions, so weak acids and weak bases are also weak electrolytes.

Answer:

H2 and O2

Explanation:

A coffee cup calorimeter is basically a type of calorimeter that operates at constant pressure. The heat measured in the calorimeter is equal to the change in enthalpy of the reaction.

This type of calorimeter is apt for reactions involving solutions where there is little or no change in volume.

It is not generally applicable to gas phase reactions such as the reaction between H2 and O2.

Answer:

You will not measure the enthalpy of the reaction of

✔ H2 and O2

in the coffee cup calorimeter because this reaction involves gases. Instead, you will use a well-known published value.

C. H2 and O2

Is Correct

Answer:

2Li + ZnBr2 ->2LiBr + Zn

3Ca + Al2O3 ->2Al + 3CaO

Explanation:

Spontaneous reactions are reactions that can happen on their own. For a spontaneous reaction to occur, a metal that is higher in the activity series must displace a metal that is lower in the activity series from its solution and not vice versa.

If we look at the two reactions selected in the answer, lithium is above zinc in the activity series and calcium is above aluminum in the activity series hence the two reactions occur spontaneously.

Answer:

slope = 3

Explanation:

[tex]slope = \frac{3 - 0}{1 - 0} \\ = 3[/tex]

Answer:

Antoine Lavoisier and Johann Wolfang Döbereiner organized the elements based on properties such as how the elements reacts or whether they are solid or liquid.

Explanation:

The periodic table of the elements as we have it today was developed as a result of the work of several notable centuries who lived centuries apart, all of who made notable contributions to development of the modern periodic table in use today.

In 1789, Antoine Lavoisier, a French Chemist provided a definition of elemets which he defined as a substance whose smallest units cannot be broken down into a simpler substance. He further grouped the elements into two as metals and nonmetals.

In 1829, German physicist Johann Wolfang Döbereiner arranged elements in groups of three in increasing order of atomic weight and called them triads. His arrangement owasf elements into triads was based on his observation of similarities in physical and chemical properties of certain elements.

John Newlands, a British Chemist was the first to arrange the elements into a periodic table with increasing order of atomic masses.

In 1869, Russian chemist Dmitri Mendeleev developed a periodic table which provided a framework the modern periodic table. He arranged the elements according to their atomic weight, leaving gaps for elements that were yet to be discovered.

The modern periodic table arranges elements based on increasing atomic number.

Answer:

B. Prepare solutions of different acid concentrations, measure 50 milliliters of each into different beakers, and place metal samples of different types but of the same mass into the beakers.

Explanation:

Since Michael is studying the factors that affect corrosion of metals, and wants to test the effect that different concentrations of an acid will have on the corrosion of a metal, using different acid concentrations of the same volume on different metal samples of the same size would give a much better than all the other options because, a standard volume of acid is used and also a standard mass of metal is used. So, the effect can be measured quantitatively since we have the same quantity of sample.

So, option B is the answer

Answer:

That is, a pH meter is useful in detecting or knowing the acidity (due to ions) or alkalinity (due to ions) of a solution. Thus, we can conclude that out of the given options it is true about a pH meter that it can be used in any acid-base titration

Answer: D. It can be used in any acid-base titration.

Explanation:

Answer:

Tetrahedral, sp3, p

Explanation:

C has 4 bonds and hence its tetrahedral shape with 109.5 degrees. since there are 4 bonds, it is sp3

Answer:

A carbon atom that is surrounded by four hydrogen atoms has a

✔ tetrahedral

molecular geometry.

This geometry results from the arrangement of the

✔ four sp3

hybrid orbitals around the carbon atom.

They are formed when the s-orbital and

✔ three p

-orbitals mix, or hybridize.

Explanation:

Answer:

Solution :

Lithium

Z = 3

P = 3

E = 3 = (2, 1) p=3

A = 7 n=4

P + n = A

3 + n = 7

N = 4



Carbon

Z = 6

P = 6

E = 6 = (2, 4) p=6

A = 12 n=6

P + n = A

6 + n = 12

N = 6

Answer:

c i took the text

Explanation:

Answer:

The amount of heat required is 4681.6 J.

Explanation:

mass, m = 16 g = 0.016 kg

initial temperature, T = 5 C

final temperature, T' = 75 C

specific heat, c = 4.18 J/g C

The amount of heat required is

H = m c (T'- T)

H = 16 x 4.18 x (75 - 5)

H = 4681.6 J

Answer:

d sguro

Explanation:

I'm not sure kung ayan ba