a bus increase its velocity from 30m/s to 45m/s and covers 300m distance. Find the time​

Answer:

the ratio of the number of turns in the primary and secondary coils.

Explanation:

hope i'm not too late!!

Answer:

c

Explanation:

Answer:

H,G,E,D,C,B,A,I,F

Explanation:

F is an ignious intrusion and I cross cuts H to A so it must be newer.

Answer:

i think its A

Explanation:

I hope this helps :)

Explanation:

Hydrostatic pressure, P = hdg where d is density if the liquid ( water)

P= 150m × 1000kgm-3 × 10ms-2

P= 1.5 ×10^6 Pa

Answer:

sodium chloride. .....

The ratio of the electric force to the gravitational force between the two electrons is [tex]4.2 \times 10^{42}[/tex].

The given parameters;

The electrostatic force between the two electrons is calculated as follows;

[tex]F_c = \frac{kq^2}{r^2} \\\\[/tex]

The gravitational force between the two electrons is calculated as follows;

[tex]F_g = \frac{Gm_e^2}{r^2}[/tex]

The ratio of the electric force to the gravitational force between the two electrons is calculated as follows;

[tex]\frac{F_c}{F_g} = \frac{kq^2}{r^2} \times \frac{1}{\frac{Gm^2}{r^2} } \\\\\frac{F_c}{F_g} = \frac{kq^2}{r^2} \times \frac{r^2}{Gm^2} \\\\\frac{F_c}{F_g} = \frac{kq^2}{Gm^2}\\\\[/tex]

[tex]\frac{F_c}{F_g} = \frac{(8.99 \times 10^9) \times (1.6 \times 10^{-19}))^2}{(6.67 \times 10^{-11} ) \times (9.11 \times 10^{-31})^2} \\\\\frac{F_c}{F_g} = 4.2 \times 10^{42}[/tex]

Thus, the ratio of the electric force to the gravitational force between the two electrons is [tex]4.2 \times 10^{42}[/tex].

Learn more about electrostatic force here: https://brainly.com/question/16796365

Answer:

Drums, harps, recorders, and bagpipes.

Explanation:

Answer:

you are very kind Po lang

Answer:

1) 4 x 25m = 100m

2) 0 because after 4 lengths, he's back at the starting block.

3) speed is distance over time so speed here is 100m/125s = 0.8m/s

4) ...

5) 100m / 1.25m/s = 80s

6.a) 100m / 0.5m/s = 200s

7.b) ... can't draw this now..

Answer

Estimates vary, but, on average, each person uses about 80-100 gallons of water per day, for indoor home uses.

Explanation:

Answer:

Explanation:

The common observable evidence are:

The big bang is the theory which explains that how the universe began. It says that the universe began with just a single point. It went on expanding and stretched to grow as large as possible. It is still now expanding.

The big bang consist of fully dark matter, interstellar gases or dust. The big bang is increasing just because in universe there is abundant of hydrogen and helium.

The radiations come from the big bang. These rays are also called as cosmic wave. This big bang is still on it way of expanding more.

Thus, the observational evidence are the measured abundances of element, the expansion of space and the cosmic wave background.

Learn more about big bang.

brainly.com/question/18297161

#SPJ2

[tex]▪▪▪▪▪▪▪▪▪▪▪▪▪  {\huge\mathfrak{Answer}}▪▪▪▪▪▪▪▪▪▪▪▪▪▪[/tex]

The work done in the given case is 0

[tex] \large \boxed{ \mathfrak{Step\:\: By\:\:Step\:\:Explanation}}[/tex]

For calculating the work done by an object we apply the formula, that is ~

where f represents force applied, and s represents displacement.

but here, the displacement is zero since the wall didn't move at all, Therefore If we plug it's value as 0, we get

hence,

So therefore, we can conclude that the man hasn't done any work.

Hope it helps.

Do comment if you have any query.

Answer:

3.125 Kilometers

Explanation:

To answer this you just multiply 12.5 by .25 (since 15 minutes is a quarter of an hour) to get 3.125 kilometers ridden.

Answer:

A.)a=44.57m/s

B.)f=38,909.61

C.)f=666.4

Explanation:

A.) A=v/t 26.3/0.590=44.57

B.) 873kg x 44.57= 38,909.61

C.) 68kg x 9.8=666.4

Answer:

Decreasing the velocity

Explanation:

The primary factor in decreasing the kinetic energy of an object is to decrease the velocity of the object.

The kinetic energy of an object is the energy which it possesses due to the motion of the object. Kinetic energy is defined as the work which is needed to accelerate an object of a given mass from the state of rest to its stated velocity and direction. Gain of the energy during the acceleration of an object, the body maintains this kinetic energy unless its speed changes and the object accelerates.

The kinetic energy is directly proportional to the mass and the velocity of the object. The primary factor which is responsible for the decrease in the kinetic energy of an object is to decrease the velocity of the object.

Learn more about Kinetic energy here:

https://brainly.com/question/15764612

#SPJ6

Answer:

its a sure for not but i think its a 192583

(a) The normal force on the block is 50.92 N.

(b) The horizontal force on block keeping it in equilibrium is 29.4 N.

The given parameters;

The normal force on the block is calculated as follows;

[tex]F_n = W \times cos(\theta)[/tex]

where;

[tex]F_n = mg \times cos(\theta)\\\\F_n = 6 \times 9.8 \times cos(30)\\\\F_n = 50 .92 \ N[/tex]

The horizontal force on block keeping it in equilibrium is calculated as follows;

[tex]F- F_x = 0\\\\F-mgsin\theta= 0\\\\F = mgsin\theta\\\\F = 6 \times 9.8 \times sin(30)\\\\F = 29.4 \ N[/tex]

Learn more here:https://brainly.com/question/24860178

Answer:

7.84 s

Explanation:

Ok, one step at a time. We know the mass of the projectile, we know the force. Acceleration is easily obtained from Newton second law:

[tex]\vec F = m\vec a[/tex][tex]2.5\times 10^5 = 5.6a \rightarrow a = (2.5/5.6) \times 10^5 = 4.46 \times 10^4 ms^-^2[/tex].

At this point, we know the acceleration, we know initial and final velocity, we can time the ammount of time it took to get there.

[tex]v= v_0 +at \rightarrow 3.5\times10^3 = 0 + 4.46\times10^4 t\\t= \frac{3.5\times10^3}{4.46\times10^4} = 7.84 s[/tex]

Answer:

So the people in the ring don't get hurt or break anything on impact once they hit the floor

Answer: figuratively speaking both the lines for the force Q and force P is equal.

Answer:

Δx=7.35m

Explanation:

This is a free fall problem (g= -9.8 m/s²).

Displacement: ? <--- what you're trying to find (max height)

Initial Velocity: 12 m/s

Final Velocity: 0 m/s <-- since the can will land back in your hands

Time: Missing <-- not needed to solve

Acceleration: -9.8 m/s²

The equation that you will use is vf²=vi²+2aΔx

Now plug the information into the equation!

(0m/s)²=(12m/s)²+2(-9.8m/s²)Δx

Multiply the 2 with the acceleration (-9.8m/s²)

(0m/s)²=(12m/s)²-19.6m/s²Δx

Now you need to square the final and initial velocity

0m/s=144m/s-19.6m/s²Δx

Move 144 to the other side of the equal sign

-144m/s=-19.6m/s²Δx

Divide both sides by -19.6m/s²

7.346m=Δx

You can round it to the tenth or hundreth place, up to you!

For this example, I'll round to the hundredth...

Δx=7.35m

I would double check this answer or review it yourself to see if it's correct.

Good luck with your studies!

Answer:

Mass = mass of nucleus

Atomic Number = number of protons (charge) of nucleus

Mass - Atomic Number = number of neutrons

Answer:

the change of speed!

Explanation:

if light speeds up or slow down more it bend more

simple subtract and ummmmmm.....

Answer:

c:   spin

Explanation:

it's not curvature

The most applicable term to a discussion of angular momentum in the context of black holes is Spin. Thus, the correct option is C.

Angular Momentum is defined as the property of any rotating object which is given by the product of the moment of inertia of an object and the angular velocity of the rotating object. Angular momentum is a vector quantity and it has both the magnitude and direction. The examples of angular momentum are the rotation and revolution of the Earth.

When the astronomers claim that they have estimated the spin of a black hole, this means they have measured its angular momentum. This is the total angular momentum of all the materials on the Universe that ever crossed the event horizon and got trapped inside it.

Therefore, the correct option is C.

Learn more about Angular momentum here:

https://brainly.com/question/29563080

#SPJ2

Answer:

  see attached

Explanation:

It will be easier to plot the data if you have grid lines to work with.

In the attached, we had to reverse the order of entries in the table, because the graphing program likes the independent variable listed first.