A 0.015 kg marble sliding to the right at 0.225 m/s on a frictionless surface makes an elastic head-on collision with a 0.015 kg marble moving to the left at 0.180 m/s. After the collision, the first marble moves to the left at 0.180 m/s. Find the velocity of the second marble after the collision.

5.08 m

Explanation:

The weight of the electron is being counteracted by the attractive electrostatic force exerted by the proton above it. We can write the force equation as follows:

[tex]m_eg = k_e\dfrac{Q_pQ_e}{r^2}[/tex]

where the Q's are the charges of the proton and electron, r is the distance between the particles, g is the acceleration due to gravity, [tex]m_e[/tex] is the mass of the electrons and [tex]k_e[/tex] is the Coulomb constant. So solving for r, we get

[tex]r^2 = k_e\dfrac{Q_pQ_e}{m_eg}[/tex]

Taking the square root of r^2, we then get the distance as

[tex]r = \sqrt{k_e\dfrac{Q_pQ_e}{m_eg}}[/tex]

The values are given as follows:

[tex]m_e = 9.11×10^{-31}\:\text{kg}[/tex]

[tex]g = 9.8\:\text{m/s}^2[/tex]

[tex]Q_p = Q_e = 1.60×10^{-19}\:\text{C}[/tex]

[tex]k_e = 8.99×10^9\:\text{N-m}^2\text{/C}^2[/tex]

Putting in all of these values in our equation for r,

[tex]r = \sqrt{\dfrac{(8.99×10^9\:\text{N-m}^2\text{/C}^2)(1.60×10^{-19}\:\text{C})^2}{(9.11×10^{-31}\:\text{kg})(9.8\:\text{m/s}^2)}}[/tex]

[tex]\:\:\:\:\:= 5.08\:\text{m}[/tex]

Answer:

4 cm

Explanation:

Amplitude is the measure from the MIDLINE to the peak of the wave....so the wave HEIGHT is twice the ampltude

2 x 2 cm = 4 cm

Answer:

The answer should be 3-At sunset blue light is scattered by air molecules at higher altitudes. The longer red and yellow wavelengths must travel further through the atmosphere when the Sun is near the horizon. At some point the reds and yellows finally scatter in the lower atmosphere causing the reds and yellows.

Answer:

3. At sunset blue light is scattered by air molecules at higher altitudes. The longer red and yellow wavelengths must travel further through the atmosphere when the Sun is near the horizon. At some point the reds and yellows finally scatter in the lower atmosphere causing the reds and yellows.

Answer:

Frictional force is produced when two bodies are rubbed against each other. It is the force that oppose the motion and therefore it stops or slow down a moving body.It depends upon the roughness or smoothness of the surface of the body in contact.Rough surface have more friction that the smooth surface. Similarly, the heavier body produces more friction than a lighter body. Frictional force acts in the opposite direction of the motion of the body.

Answer:

less

Explanation:

heat travels from hotter to colder object. hotter object has more kinetic energy.

Answer:

Our eyes are most sensitive to the wavelengths corresponding to the yellow and green colors of the spectrum. Flashy signs and some fire engines are painted in a yellowish-green color to attract our attention.

Answer:

Explanation:

(i) μs = F/N = mgsinθ/mgcosθ = tanθ

  tanθ = 0.3

  θ = 16.7°

(ii) a = F/m

    a = (mgsinθ - (μk)mgcosθ) / m

    a = g(sinθ - (μk)cosθ)

    a = 9.8(sin16.7 - (0.2)cos16.7)

    a = 0.94 m/s²

(iii) s = ½at²

     t = √(2s/a)

     t = √(2(1)/0.94)

     t = 1.5 s

Answer:

True

Explanation:

Magnitude is the "value" the greater the value the greater the force is and vice versa

Answer:

TRUE

Explanation: I did the test

Hope this helps

100000 Pascal

Explanation:

pressure= force/area

Max pressure= force/min area

so f=5

min area= 5×10^-5

5÷5*10^-5 = 100000pascal

No,the poping of microvave is not same there time is different

Answer:

yes

Explanation:

because gravity moves things

Answer: False

Explanation:

It's received in elliptical cavities.

False. The statement is not entirely accurate. Condyloid joints are a type of synovial joint that allow movement in two planes, similar to an ellipsoid joint.

These joints are characterized by an oval-shaped projection of one bone fitting into an elliptical cavity of another bone. The term "condyle" does refer to a rounded projection or bump on a bone, but not all condyle bone markings create condyloid joints.

Condyloid joints are found in various parts of the body, such as the wrist (between the radius and carpal bones) and the knuckles (between the metacarpal bones and phalanges). They allow for movements such as flexion, extension, abduction, adduction, and circumduction.

It's important to note that the formation of a condyloid joint involves not only the presence of condyle bone markings but also the specific structural arrangement of the bones and the presence of articular cartilage, joint capsule, and synovial fluid. Therefore, while the term "condyle" is related to these joints, it does not accurately capture the complexity of their formation and function.

To learn more about Condyloid joints, here

https://brainly.com/question/30165924

#SPJ3

Ryder is testing the change in motion for an object that weighs 25 kg and an object that weighs 30 kg. Then, the greater change in motion is due to the greater mass of the object, and the object will have a greater change of motion. Thus, the correct option is C.

Motion is the phenomenon in which an object changes its position with respect to the time taken. Motion of an object is mathematically described in terms of the displacement covered by the object, the distance, velocity, acceleration, speed and the frame of reference to an observer and measurement of the change in the position of the body of an object relative to that particular frame with the change in time taken.

The motion of an object is proportional to the mass of the object. The mass is greater in this case, and therefore the objects will have a greater change of motion.

Therefore, the correct option is C.

Learn more about Motion here:

https://brainly.com/question/22810476

#SPJ1

Answer:

True

Explanation:

Since positive and negative forces are both opposites of each other they attract. But if the forces are the same where both are positive or negative thye repel do to being the same charges in that case the picture would show lines moving in opposite directions.

Answer:

Refractive index of a medium = Speed of light in vacuum/Speed of light in a medium

1.5 = 3 x 108 / Speed of light in medium

Speed of light in the medium = 3 x 108 /1.5

= 2 x 108 m/s.

Explanation:

Answer:

C) high efficiency light bulbs, because they produce more heat

Light bulbs produce useful energy in the form of light and waste energy in the form of heat, the kind of light bulb would you use to incubate eggs are low-efficiency light bulbs, because they produce more heat, therefore the correct answer is option B.

It can be defined as the form of the energy in which heat is transferred from one body to another body due to their molecular movements, thermal energy is also known as heat energy.

The type of light bulb you would use to incubate eggs is a low-efficiency light bulb since they produce more heat; consequently, option B is the right response. Light bulbs produce useful energy in the form of light and waste energy in the form of heat.

To learn more about thermal energy here, refer to the link given below ;

brainly.com/question/3022807

#SPJ2

This question involves the concepts of tension in a string and the wavelength of the wave in a string.

The wavelength of a sinusoidal wave will "increase by square power" on a string if the tension in the string is increased when the frequency is kept constant.

The speed of a wave on a string is given by the following formula:

[tex]v=\sqrt{\frac{T}{\mu}}[/tex]

where,

v = speed of wave = fλ

f = frequency of the wave

λ = wavelength of the wave

T = tension force

μ = linear mass density of the string

Therefore,

[tex]f\lambda=\sqrt{\frac{T}{\mu}}\\\\T = f^2\lambda^2\mu[/tex]

It is given that the frequency is kept constant. The linear mass density is also constant for a string. Therefore,

[tex]T=(constant)\lambda^2\\T\ \alpha\ \lambda^2[/tex]

Learn more about string tension here:

https://brainly.com/question/4087119?referrer=searchResults

The maximum magnitude of the friction force exerted on the box by the ramp is 44.41 N.

The given parameters;

The normal force on the wooden box is calculated as follows;

[tex]F_n = mg \times cos(\theta)\\\\F_n = 10 \times 9.8 \times cos(25)\\\\F_n = 88.8 2 \ N[/tex]

The maximum magnitude of the friction force exerted on the box by the ramp is calculated as follows;

[tex]F_f = \mu \times F_n\\\\F_f = 0.5 \times 88.82 \\\\F_f = 44.41 \ N[/tex]

Learn more about static frictional forces here: https://brainly.com/question/4515354

Answer:

B. A bat finds a moth using echolocation

Explanation:

100% i just took that test today

Answer:

1.904

Explanation:

F= ma

8 = 4.2 a

a = 8/4.2

a = 1.904

Answer: 100cm = 1 meter.

Centi is 100, therefor meaning that 100cm is exactly 1 meter.

I hope this helps!

Answer:

the action or process of moving or being moved.

Explanation:

which an object changes its position over time

Answer:

A. For every action there is an equal and opposite reaction.

Answer:

well for C the horse is at rest at 10 to 15

D is 0 to 10

E is 15 to 25

Explanation:

If you search up examples it will help with this worksheet.

If I am work then I appologize

Answer:

25.0 cm3

Explanation:

The volume is 25.0 cm3 .

Newton's laws allow to find the result for the movement of the basketballl:

Newton's laws establish the relationship between the forces on objects:

Let's apply these principles to the ball's motion diagram.

The two vertical forces are in the opposite direction, one is due to the weight of the body and the other is the attraction of the earth to the support of the ball, they are of equal magnitude, not their action-reaction force and reluctant because it is applied to the same body

       In conclusion we can say that the ball is on the ground.

The two horizontal forces are in the opposite direction, the thrust force is greater than the friction therefore using Newton's second law the ball must be accelerating in the direction of the thrust force.

       In conclusion we can say that the ball is accelerating in the direction of the pushing force.

In conclusion using Newton's laws we can find the result for the motion of the basketball:

Learn more about Newton's laws here:  brainly.com/question/3715235

The speed of the chord wave allows finding a new speed when the mass is increased and the chord length is:

A wave is a periodic movement of the particles that carries energy, but not matter, the speed of the waves is related to the properties of the medium by the relationship.

           [tex]v = \sqrt{\frac{T}{\mu } }[/tex]  

Where v is the speed of the wave, T the force and μ is the linear density.

Indicates that the applied mass increases by a factor of 18.0 and the length of the head is increased to twice the original.

The linear density of the cable is

          [tex]\mu = \frac{m}{l}[/tex]

Where m is the mass of the cable and l is the length.

Let's use the subscript "o" for the initial conditions.

          M = 18.0 m₀

          l = 2 l₀

We look for the density.

         [tex]\mu = \frac{18.0 m_o}{2.0 l_o}[/tex]mu = 18.0 mo / 2 lo

         [tex]\mu = 9.0 \mu_o[/tex]  

We substitute in the expression for the velocity assuming that the tension is kept constant.

        [tex]v= \sqrt{\frac{T}{9.0 \mu} }[/tex]  

        [tex]v= \frac{v_o}{3}[/tex]  

In conclusion, using the speed of the chord wave we can find a new speed when the mass is increased and the chord length is:

Learn more about wave speed here:  brainly.com/question/16824509

Answer:

d

Explanation:

A dreams

.......wkkwkwkwkwkwnwnsksk

Answer:

C. short term goal

Explanation:

took a midterm quiz on canvas, Hope this helps <3

The value of the constant K is [tex]\mathbf{K = \dfrac{1}{LC}}[/tex]

According to Kirchhoff's loop rule, the total algebraic sum of potential differences in any loop, combining voltage provided by voltage sources as well as resistive components, must equal zero.

Thus, the relation for Kirchhoff's loop rule can be expressed as:

[tex]\mathbf{\dfrac{q}{c}- L\dfrac{dI}{dt} = 0}[/tex]

We all know that the current in the nonconstant charge flow can be written as:

[tex]\mathbf{I = \dfrac{dq}{dt}}[/tex]

∴

Replacing the current (I) into Kirchhoff's loop rule, we have:

[tex]\mathbf{ L\dfrac{d}{dt} ( \dfrac{dq}{dt})= -\dfrac{q}{c}}[/tex]

[tex]\mathbf{ \dfrac{d^2q}{dt^2}= -\dfrac{q}{Lc} \ \ ---(1)}[/tex]

From the given question, when the switch is closed

[tex]\mathbf{ \dfrac{d^2q}{dt^2}= -kq\ \ ---(2)}[/tex]

Then, the charges on the capacitor start to b, resulting in the rise of the current in the circuit.

∴

By equating both equations (1) and (2);

[tex]\mathbf{K = \dfrac{1}{LC}}[/tex]

Learn more about Kirchhoff's loop rule here:

https://brainly.com/question/14681219?referrer=searchResults